Your coupon for will be reflected when you check out!
✖
Your coupon for
✖
Hello!
You're visiting the PartSelect site in U.S.
Would you like to shop on the Canadian site?
Stay on this site
Go to Canadian site
✖
Model Number Locations
1Select Category Type
Select Category Type
2Select Product Type
Select Product Type
3Select {MODEL} Type
Select {MODEL} Type
Sample Model Number Tags
Model numbers can be made up of numbers (1005400, for example) or a combination of letters and numbers (LAT1000AAE). The model number will most likely appear on either a paper sticker or a metal plate. Your appliance's model number tag may look similar to the sample model number tags shown here (model number highlighted in yellow):
Model has been saved to My Models. If you're not signed in, your lists are available on this device and will expire within 30 days.
Model has been saved to My Models.
This oven bake element with push on terminals is a closed hinged bake element. The push on terminals are 1-3/8 inch, and the distance between the two is 1 inch.
This eight inch two wire monotube style surface element from Frigidaire carries 2400 watts and 250 volts. Use it for your GE made Frigidaire/WCI brand gas range.
just diconnected the electric unscrewed the 2 screws that held the element in place, then i unplugged the old element, plugged in the new element, replaced the 2 retaining screws. that was it! Frigidaire customer service had no clue how to help me find this element for an old wall mount oven. I spent over a half hour on the phone with the
... Read morem. The cool part about parts select is, I was on the phone with them less than 5 minutes and had already found and paid for the element i was looking for. on and off the phone in less than 5 minutes. Thanks a lot parts select, what a great experience doing business with you.
Very easy to replace old bake element with new one. Used screw driver to remove the old element, disconnected wires then connected wires to new element and used the screw driver to secure new element.
After removing the 2 screws, pulling the element out, & disconnecting the 2 wires, I started installing the new element. 20 years ago, this may have been easy, but...after so many years of use, and grease fumes and who knows what, the new connections were difficult to connect. However , after a few choice words and a few alcoholic bever
... Read moreages, the new burner was installed and it works great! Thank you & keep stocking those "old" parts. I have 3 more burners & an oven fixture left ta go!
