RC244RDA (DS83A) Magic Chef Refrigerator - Overview
Sections of the RC244RDA
[Viewing 8 of 8]
Keep searches simple, eg. "belt" or "pump".
Refrigerator Screw
PartSelect #: PS11740623
Manufacturer #: WP3-24838-048
Sold individually.
$7.30
In Stock
Egg Tray
PartSelect #: PS11743588
Manufacturer #: WP67004411
This egg tray holds fourteen eggs.
$9.40
In Stock
Lower Hinge Pin
PartSelect #: PS2073817
Manufacturer #: 69845-1
This pin is used with the lower hinge assemblies of both the fresh food door and the freezer door of side by side refrigerators.
No Longer Available
Refrigerator Door Shelf - White
PartSelect #: PS2073662
Manufacturer #: 69607-1
Also known as the front pick-off shelf.
No Longer Available
Washer
PartSelect #: PS11742796
Manufacturer #: WP52185-1
This door hinge washer is less than an inch in diameter. It is all white in color and it is made entirely of plastic.
$11.50
Special Order
Fresh Food Door Gasket
PartSelect #: PS11743823
Manufacturer #: WP70024-4
This white door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.
No Longer Available
Questions And Answers for RC244RDA
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Pantry Drawer Cover keeps falling off, not held in place by End Cap Kit
I removed the 2 crisper drawers and the glass shelf directly above the Pantry Drawer. Removed the Pantry Drawer and Pantry Drawer cover so you have easy access to the Right-Hand End Cap. On the right-hand End Cap, there are 2 screws which hold the End Cap in place, use a 1/4 inch driver to unscrew the screws from the front of the cabine
... Read more
t on the End Cap and half-way in of the cabinet, leave the screws in their holes in the End Cap. Lift gently to get off a small plastic pin, and move the End Cap away from the Cabinet. You don't need to completely pull the End Cap out of the cabinet, it'll move more like a door opening. Place 2 washers on each screw and gently put the End Cap back into place, being careful NOT to jostle too much so the washers don't fall off the screws. You will need to gently lift the End Cap back in to place over the plastic pin. Hand-tighten the screws back into place with the 1/4 in driver. Remount the Pantry Drawer on the sliders. When you go to install the Pantry Drawer Cover, you will need to gently push on one of the pins to get the cover back into place. Put glass and crisper drawers back into place.
Test by gently pulling on the Pantry Drawer. If properly mounted, the pins will extend fully into the Cover and will keep it secure when opening the Pantry Drawer.
Test by gently pulling on the Pantry Drawer. If properly mounted, the pins will extend fully into the Cover and will keep it secure when opening the Pantry Drawer.
Read less
Parts Used:
-
Gerald from TANEYTOWN, MD
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Nutdriver
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!