R-151 - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
microwave turn table motor was not working at all. so food cooked unevenly.
ordered part, removed two bottom-front screws that hold the bottom plate of microwave closed (note back of plate is on hinges so it stayed attached to microwave when we opened it.unplugged broken motor, plugged in new motor,replaced the two screws and...yeh!!! works like new. Thanks for the suprisingly rapid delivery of this part.We give your company five stars for service, delivery, and the very small part needed.!!!
Parts Used:
-
Margie from Shelby Township, MI
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
6 of 12 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
lcd on sharp r1514 mircowave was illegible
Normal phillips screwdriver used for everything. Unplug microwave, remove top grille (3 screws in grille), remove 1 screw from just above and to the right of the display. Lift panel up, and replace with new board. Have to unplug about 7-8 items and a strip. Would be able to do again in less than 10 minutes, but first time took about 20-25 minutes after spending a couple of hours researching. (some of the research was misleading as you DO NOT have to take the microwave down from range if just accessing control panel)
Parts Used:
-
Stephen from Brisbane, CA
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
2 of 3 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!