Models > PR65Y21C > Instructions

PR65Y21C Lawn Mower - Instructions

All Instructions for the PR65Y21C

Cable was broke.

Pushed the cable through the engine mount.Connected the cable to the engine slider. Pulled cable through the previous tie down connected to the lower end of the bar. Attached the connector on the cable to the hole in the lawn mower bar near the top of the bar.. Attached the top end of the cable to the on/off bar where you push the mower.

Parts Used:

Lawn Mower Engine Control Cable

James from ASHTABULA, OH
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers

6 of 7 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

I did not have a special wench

I mowed until gas was empty. No bottom plug had to turn mower on side and drained oil. I had buy special lubricants to remove blade bolt. That was a challenge. I called a friend to help place new blade on. Put in new filter, oil, and gas. Mower works great!

Parts Used:

Lawn Mower Blade Adapter

Blade

Lawn Mower Hardened Washer

Sharon from MCMINNVILLE, TN
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Wrench (Adjustable)

1 person found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Front drive wheel locked up, causing the mower to not be able to be pushed.

Removed wheel by pressing off the plastic hub cap exposing the nut holding the wheel. I removed the nut, then pulled the wheel straight off the axel shaft. This exposed the broken dust cover. I they wiggled the dust cover off, cleaned the dirt from inside the wheel, placed the new dust cover, replaced the wheel, nut and hub cap.

Parts Used:

Lawn Mower Wheel Dust Cover

Walter from EVERETT, WA
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Socket set

2 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

My lawn mower blade wouldn’t stay in place. The old blade adapter had worn down and broken.

I took off the old blade adapter and put the new one on. It literally requires removing one bolt. Unfortunately, once I started and ran my mower for a few minutes it blew up and left a charred patch of lawn. The underside of the mower is mangled metal and unusable now. The repair, though, was super easy!

Parts Used: