Your coupon for will be reflected when you check out!
✖
Your coupon for
✖
Hello!
You're visiting the PartSelect site in U.S.
Would you like to shop on the Canadian site?
Stay on this site
Go to Canadian site
✖
Model Number Locations
1Select Category Type
Select Category Type
2Select Product Type
Select Product Type
3Select {MODEL} Type
Select {MODEL} Type
Sample Model Number Tags
Model numbers can be made up of numbers (1005400, for example) or a combination of letters and numbers (LAT1000AAE). The model number will most likely appear on either a paper sticker or a metal plate. Your appliance's model number tag may look similar to the sample model number tags shown here (model number highlighted in yellow):
PHP9030DJ2BB (2018) General Electric Range - Overview
Save your modelModel Saved!
Save your model for later to make things easier.
Model has been saved to My Models. If you're not signed in, your lists are available on this device and will expire within 30 days.
Model has been saved to My Models.
This is foam tape and it is usually used in conjunction with your range, specifically on the cooktop. Its purpose is to help seal the edges of the cook top to the counter top. Another of its functions...
Upgrade your kitchen range with this sleek and durable GE installation kit. Specifically designed to ensure a secure and precise fit, this essential kit includes everything you need for a successful r...
This kit controls induction heating functions. Replace if the cooktop stops heating or shows error codes. This part is designed to keep your appliance operating reliably and efficiently. Replacing a w...
First, I disconnected the power, unwired the unit, and lifted it out of the counter by using a knife to cut the foam tape located between the glass and the counter. Next, I placed in upsidedown on the floor which was covered with a soft blanket. Then I removed the screws to lift off the cover. I removed the cables from the circuit board o
... Read moren the broken glass. I removed the double-sided tape between the glass and the unit. I replaced the double-sided tape. I installed the new glass, re-attached the wires and the screws. I put fresh foam tape around the outside. I put the cooktop back into the counter and re-attached the wiring, and turned on the breaker.
Important: When the cooktop powered on, you must select the GUI mode (A1 A2 C1 or C2) corresponding to your cooktop model, then press Enter for 7 seconds to lock it in or else it will not work. Once that was done, it works great.
