Quick Question!

Have you ever purchased from PartSelect.com before?

Models > PCG23NHMFFBB

PCG23NHMFFBB General Electric Refrigerator - Overview

Get Parts and Repair Help for PCG23NHMFFBB

If you know the refrigerator repair part you need, you can browse the list of all parts on the PCG23NHMFFBB, or you can search by name or part description. You can also find your part by where it is located on the PCG23NHMFFBB by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for PCG23NHMFFBB parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$11.31

Temperature Sensor

This temperature sensor, also known as a thermistor, is used for refrigerators and freezers. The sensor sends the temperature reading of the refrigerator towards the control board....

$13.20

Defrost Thermostat

This defrost termination thermostat acts as a safety device to stop the evaporator coil from overheating, by turning off the defrost heater at the end of the defrost cycle. The thermostat measures the temperature in your freezer to ensure that it stays at an optimum temperature to keep your frozen food from thawing. Some common symptoms linked to a faulty defrost termination thermostat include: the freezer is not defrosting, is too cold/too warm, or there is a frost build up in the freezer. Before you decide to replace this part, ensure that there is no frost build up in your freezer; as a build up can interfere with the thermostat reading.

$65.78

Ice and Water Filter

This is an ice and water filter. The most common reason you would need to change this part is if you have never updated your model and it is no longer filtering your water. This al...

$19.00

Module Shelf Insert

This part is located in the front of the module shelf.

$7.53

Dispenser Door Assembly or Flapper

The dispenser door assembly (or flapper) is what opens to release the ice once the lever has been pressed. This part mounts in the ice dispenser. The cranker no longer comes with t...

$41.11

Dispenser Door Solenoid Assembly

This part is a possible option when ice door won't open or shut properly or when water is not dispensing.

$2.58

Dispenser Light Bulb - 12V

Sold individually.

$3.52

Recess Door Spring

$4.07

Light Switch

$1.90

Compression Ring

This compression ring is meant to hold the evaporator fan motor in place in the freezer compartment of your refrigerator. This is is a genuine OEM part. The tools needed to complete this repair are a Phillips screw driver and small flat blade screw driver. Be sure to turn off your refrigerator before removing the evaporator fan cover so the fan does not turn on during repair. It is recommended to check the grommets, evaporator fan, and fan blades during repair in case they also need replacning. The compression ring may need replacing if the fan is noisy, or the refrigerator compartments are too warm. This part is sold individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Fridge too warm, evaporator icing up

  • Customer: Gerald from San Clemente, CA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 471 of 561 people found this instruction helpful
After replacing the defrost heater, main board and thermistor I still had the same problem. Called a repair guy and he (with the help of GE on the phone) diagnosed that the temperature sensor was bad. So I ordered from partselect and installed it and it fixed the problem. Been good for a couple months (knocking on wood). To install I had to cut the 2 wir... read more

flap to ice dispenser would not close

  • Customer: Bill from Cleveland Heights, OH
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 393 of 452 people found this instruction helpful
The flap to the ice dispenser would not close, which allowed the ice dispenser to frost up, freezing the water dispenser.

This was a simple fix. The solenoid had stopped working, so it would not automatically close the door flap. I read some posts on this site that suggest that you had to remove the trim around the entire dispenser to get at the... read more

Freezer wouldn't maintain temperature ... got warm.

  • Customer: Mike from Scottsdale, AZ
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 241 of 288 people found this instruction helpful
The freezer in my side-by-side kept warming up -- often 20 degrees or more, which of course caused the fresh food side to warm up also. I do a lot of jump-in-with-both-feet home repairs, but never on a large appliance. Not having an ohmmeter, which cost about $100 for a reliable one, I took the symptoms to the internet. Countless self-help sites and U-Tube v... read more