Your coupon for will be reflected when you check out!
✖
Your coupon for
✖
Hello!
You're visiting the PartSelect site in U.S.
Would you like to shop on the Canadian site?
Stay on this site
Go to Canadian site
✖
Model Number Locations
1Select Category Type
Select Category Type
2Select Product Type
Select Product Type
3Select {MODEL} Type
Select {MODEL} Type
Sample Model Number Tags
Model numbers can be made up of numbers (1005400, for example) or a combination of letters and numbers (LAT1000AAE). The model number will most likely appear on either a paper sticker or a metal plate. Your appliance's model number tag may look similar to the sample model number tags shown here (model number highlighted in yellow):
Model has been saved to My Models. If you're not signed in, your lists are available on this device and will expire within 30 days.
Model has been saved to My Models.
This complete lower rack assembly is a genuine replacement part designed for select GE dishwashers, including models sold under Hotpoint, Haier, Monogram, and Café brands. Engineered to securely hold ...
This is the complete dishrack.
Note: This part has been updated by the manufacturer. It may appear different but will still function the same as the original.
If your fridge isn’t cooling properly or seems to be running too loud or too often, the inverter control board might be the issue. This part controls how fast the compressor runs, helping your fridge ...
This dishrack is for dishwashers.
Dishrack holds the dishes in place during the dishwashing cycle.
Follow the instructions in the manual when installing this part.
This dispenser display assembly is for refrigerators. Dispenser display assembly contains the display control board, switches and houses the touch pad for the display
This main control board acts as the central hub for managing refrigerator functions, including cooling cycles and temperature settings. A failing board can cause inconsistent cooling or error codes. T...
The repair is simple and straightforward. I rated as a bit difficult since the rack mounts on the new were located in the wrong place.
Releasing the rack from the slide rails requires either a Phillips screwdriver or a ratchet and socket.
The issue to check for, which I missed, is if the rail mounts on the new r
... Read moreack are in the same position as on the old rack. Mine were not and I did not discover until the new rack was fully installed. Once the unit was back out, 7 SS screws need to be removed on each side to move the mounts to the correct position.
Take the cardboard grill off the bottom of the back it is held on with 5-6 hex head screws. Located the voltage inverter on the tank. It's on the bottom left of the refrigerator. Removed the screw that holds it in place.Remove the jumper wires at the quick connect. Rotate the voltage inverter and removed it. Check the voltage at the plug
... Read morein going to the voltage Inverter. It should be 115-125 volts. Plug in the voltage inverter to the Quick connect away from the tank check the voltage on the side that would be connected to the tank. If both sides don't read at least 115 volts the inverter is bad. Order a new on and reinstall in the reverse order.
