Your coupon for will be reflected when you check out!
✖
Your coupon for
✖
Hello!
You're visiting the PartSelect site in U.S.
Would you like to shop on the Canadian site?
Stay on this site
Go to Canadian site
✖
Model Number Locations
1Select Category Type
Select Category Type
2Select Product Type
Select Product Type
3Select {MODEL} Type
Select {MODEL} Type
Sample Model Number Tags
Model numbers can be made up of numbers (1005400, for example) or a combination of letters and numbers (LAT1000AAE). The model number will most likely appear on either a paper sticker or a metal plate. Your appliance's model number tag may look similar to the sample model number tags shown here (model number highlighted in yellow):
Model has been saved to My Models. If you're not signed in, your lists are available on this device and will expire within 30 days.
Model has been saved to My Models.
This part is an OEM from Ryobi. The screw (m4 x 14mm bl) is compatible with a variety of lawn and garden tools. The metal screw is often used to help secure the housing assembly. This item is sold ind...
This authentic OEM fan blade, also known as an impeller or fan wheel, is found within the blower housing. Located near the tail cone assembly and the motor, it creates airflow by spinning rapidly and ...
This switch and contact plate assembly, also known as a wiring harness, is sourced from the original manufacturer for use in blowers. The switch controls the flow of electricity to either start or sto...
This OEM closed-end wire connector is a device that securely joins electrical wires in your lawn equipment. Its outside is made of plastic to insulate the connection, but there is a metal portion in t...
This switch trigger is an OEM part direct from Ryobi. The switch trigger is used to start and stop the motor on a blower. This part is made of a high-quality metal and is sold as an individual replace...
This is a genuine Ryobi replacement part that has been sourced from the original manufacturer to be used with trimmers, blowers, and edgers. The screw is used with different types of equipment and the...
Ask our experts a question about this model and we'll get back to you as soon as possible!
2 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Rob
October 31, 2023
How do I remove fan blade?
For model number P21081
Hello Rob, Thank you for writing. To replace the blade, gather a screwdriver, pliers, and a T15 driver or bit. Generally, you will need to remove the screws holding the inlet guard and blower outlet housing, detach them, locate and access the rear shaft of the motor, hold the shaft with pliers, and thread off the old fan assembly. When installing the new assembly, make sure to continue holding the shaft securely while threading it on. We hope this helps!
Did this question help you?
Thank you for voting!
Donald
October 5, 2022
How do you get the fan blade off?
For model number P21081
Hello Donald, Thank you for the question. Here is a repair story from a previous customer when replacing the Fan. 1. Remove all screws. 2. Separate both halves. 3. Remove fan housing/duct while leaving cables attached. 4. Locate shaft at rear of motor. 5. Hold shaft with pliers while backing/threading old fan assembly off. 6. Hold shaft with pliers while threading new fan assembly on. 7. Reverse steps 3-1. We hope this solves your problem!
Did this question help you?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
