Models > LC221R > Instructions

LC221R Husqvarna - Instructions

All Instructions for the LC221R

Rear drive wheels bald, no traction

9/16s inch socket, something to prop up one side of the mower (I used a plastic plant pot), and about 5 minutes was all that was needed. Undo the nut on the wheel, remove, replace it with the new one (can't mess it up - just goes on one way which is extremely obvious), replace and tighten the nut -- done. Just that simple. With the new kicks it goes up hill like a champ now (instead of spinning, especially with the grass catcher attached).

Parts Used:

Wheel & Tire Assembly, Rear

Mark from COLUMBUS, OH
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Socket set

3 of 5 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Wheels on this old mower were plastic and brittle and over the years broke off in pieces

Can't believe you all had replacement wheels for this dinosaur. They have drive gears attached to wheel. Very simple to fix but broke old exhaust chute on mower when I leaned it on its side. Now I have to find a replacement for it! Geeesh!!!

Parts Used:

Wheel & Tire Assembly, Rear

Mike from GREENFIELD, MO
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Socket set

1 person found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Front drive wheel locked up, causing the mower to not be able to be pushed.

Removed wheel by pressing off the plastic hub cap exposing the nut holding the wheel. I removed the nut, then pulled the wheel straight off the axel shaft. This exposed the broken dust cover. I they wiggled the dust cover off, cleaned the dirt from inside the wheel, placed the new dust cover, replaced the wheel, nut and hub cap.

Parts Used: