EasyApplianceParts is now PartSelect! We've merged our sites to provide a better shopping experience for you.   Full Details
Back
Back
Back
Keep typing for more specific results...
Keep typing for more specific results...
Models > JGC4430BDW14 > Instructions

JGC4430BDW14 Jenn-Air Cooktop - Instructions

All Instructions for the JGC4430BDW14
1 - 5 of 5
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
My cooktop knob melted
I had used a pan too large for the middle burner - result: melted knob. Just pulled the old one off (up and straight) and then pushed the new one down firmly. Make sure the indicator line is pointing at you, so the flat side of the spindle matched the flat side of the hole on the knob. Easy peasy.
Parts Used:
Knob
  • Anna from MONROVIA, CA
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    Less than 15 mins
10 of 11 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
black dirty burner grates
replaced grates
Parts Used:
Burner Grate - Gray
  • Carolyn from St. George, UT
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
14 of 31 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
One control knob got partially melted by a hot pan touching it.
I never did receive the part. It was a knob. Part numberPS11744700. Must've got lost in the mail. Thanks. Thomas Horne, 266 Eedmont Ct., Rogersville,Tn 37857?............P.S. The cost of it cleared my bank.
Parts Used:
Knob
  • Thomas from ROGERSVILLE, TN
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    30 - 60 mins
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Gas explosion due to bad Gas Pressure Regulator
First step is to turn gas off to cook top and also disconnect power to the unit. Than using a crescent wrench disconnect the gas line going to the unit from the Regulator. Than again using the crescent wrench disconnect the regulator from the bottom of the unit. Next remove the nipple that connects the gas line to the regulator from the old unit. Apply new pipe dope to the threads and screw it into the new one and tighten down. Next install the regulator to the unit and install the gas line to the regulator. once done with the install you can now plug the unit in and turn on the gas. You are now ready to use the cook top again
Parts Used:
REGULATOR
  • Charles from Buena Park, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Wrench (Adjustable)
2 of 14 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the JGC4430BDW14
1 - 5 of 5