Your coupon for will be reflected when you check out!
✖
Your coupon for
✖
Hello!
You're visiting the PartSelect site in U.S.
Would you like to shop on the Canadian site?
Stay on this site
Go to Canadian site
✖
Model Number Locations
1Select Category Type
Select Category Type
2Select Product Type
Select Product Type
3Select {MODEL} Type
Select {MODEL} Type
Sample Model Number Tags
Model numbers can be made up of numbers (1005400, for example) or a combination of letters and numbers (LAT1000AAE). The model number will most likely appear on either a paper sticker or a metal plate. Your appliance's model number tag may look similar to the sample model number tags shown here (model number highlighted in yellow):
GTZ21GBESS General Electric Refrigerator - Overview
Save your modelModel Saved!
Save your model for later to make things easier.
Model has been saved to My Models. If you're not signed in, your lists are available on this device and will expire within 30 days.
Model has been saved to My Models.
This 40-Watt light bulb is sold individually.
It is specially designed to withstand extreme temperatures, so this bulb is compatible with a variety of appliance types including refrigerators, ranges,...
The evaporator fan blade circulates air through the interior compartment of the refrigerator to improve the cooling efficiency. If your refrigerator is too warm, or too cold check to ensure the fan bl...
This vegetable case cover is a replacement storage component designed to sit above a drawer, helping support items and maintain organized storage. It is commonly replaced when cracked, warped, or unab...
Unplugged the appliance for safety. Removed two 1/4" screws that held the assembly in place. Carefully removed the wire guard that retains the glass shield. Unscrewed old light bulb and replaced with new part. Reversed the steps after cleaning glass cover.
I placed the freezer contents temporarily in the refrigerator section. Unplugged the refrigerator. Removed the shelf, removed four Philips screws and the cap in the upper left corner. Disconnected the Molex plug from the refrigerator wall. Placed the panel containing the evaporator motor on the workbench.Removed the plastic panel. Using
... Read morea 1/4" nutdriver removed the bracket holding the evaporator fan motor. Saved the rubber insulators holding the motor in place. Disconnected the in-line Molex connector. Mounted the new motor using the rubber insulators, reassembled the brackets, replaced the plastic air dissipation panel, reconnected the Molex connector into the refrigerator wall, remounted the panel in the freezer, reloaded the freezer and the noise was no longer and there was the cold air again.
YouTube!! All kinds of good advice in there. Figured out that the evaporator fan was not blowing cold air down into the fridge section. Ordered a new fan motor, got it in less than 2 day. Fairly easy to install. It was the fan motor ONLY- I had to save the fan blade, brackets, screws, even the rubber grommets to re-use. Just don't t
... Read morehrow out the old one 'til you're done, is my point. I almost did.
