This is a replacement wheel and stud for your lower dish rack. This part is sold individually. The wheels are easy to replace, you just need to snap them in place after removing the old one.
This part is the replacement tub gasket for your dishwasher. It is black in color and is made of rubber. The tub gasket fits around the circumference of your dishwasher tub, and creates a seal that pr...
This door spring is approximately 7 inches long. The dishwasher door spring applies tension to the dishwasher door through the door hinge to prevent the door from dropping too quickly when the unit i...
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
3 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Philippe
May 23, 2023
Hi, I am looking for the replacement front door seal/gasket for my GE diswasher. I can only find the tub gasket but there is aslo a seal at the bottom of the door, same width as the door. Can you confirm if available and part no. Thx.
For model number GLDT696D00SS
Hi Philippe, thank you for reaching out. We have researched and found one tub gasket, part number PS1481856, that creates a watertight seal between the dishwasher tub and door. The seal, which is located at the bottom of the door, comes with the inner door panel, part number PS3486954. We hope this is what you were looking for!
What is the cost for door latch and where to get it
For model number GLDT696D00SS
Hello Diana, thank you for you question. The door latch is part PS12068850 and we sell it on our site. The stock status and current pricing is on the website. We look forward to hearing from you.
Hi Marielle, thank you for reaching out. The part you are looking for is the touchpad, part number PS3486962. If you need help placing an order, customer service is open 7 days a week!
We ordered a whole new set for the lower rack and even though they were smaller than the original ones, we replaced them all and now the rack slides in and out of the dishwasher with ease!
I had to buy the inner door assembly since the seal at the bottom was not available separately. $104 for a $10 part.
Before you take anything apart, shut off the power. There is 110V in the door, and it’s pretty unforgiving.
The inner door assembly is manufactured with razor sharp edges all around. It is fastened w
... Read moreith approximately 11,000 Phillips screws, all of which fall under the dishwasher upon removal. The outer door will fall to the floor to indicate you have removed all the screws. Or, you could support the outer door, if you are smarter than I am.
Putting the new inner door on isn’t too bad. Mine was bent a little in shipping, but I bent it straight again, pretty much. I had my 19 year old son help hold it in place, so I could learn how “lame” this activity was. Once a couple of screws are installed, he can go back to sleeping 15 hours a day. Make sure the lower seal is aligned as you tighten the bottom screws.
Once you’re done, turn on the power and run the dishwasher. You’ll learn that the leak is due to a clogged discharge hose, and you just burned an hour an $104.
I pulled the dishwasher out, and discovered that the translucent pipe leading up the back of the machine was leaking at the point at which it fed into the middle tray.
