Your coupon for will be reflected when you check out!
✖
Your coupon for
✖
Hello!
You're visiting the PartSelect site in U.S.
Would you like to shop on the Canadian site?
Stay on this site
Go to Canadian site
✖
Model Number Locations
1Select Category Type
Select Category Type
2Select Product Type
Select Product Type
3Select {MODEL} Type
Select {MODEL} Type
Sample Model Number Tags
Model numbers can be made up of numbers (1005400, for example) or a combination of letters and numbers (LAT1000AAE). The model number will most likely appear on either a paper sticker or a metal plate. Your appliance's model number tag may look similar to the sample model number tags shown here (model number highlighted in yellow):
Model has been saved to My Models. If you're not signed in, your lists are available on this device and will expire within 30 days.
Model has been saved to My Models.
This is a replacement shock absorber for your washer. The shock absorber is approximately 9 inches long and a little more than one inch wide. It is black and silver in color, and is sold individually....
This washer balance ring assembly helps stabilize the wash basket during the spin cycle to reduce excessive vibration, noise, and shaking. By counterbalancing uneven loads, it supports smoother operat...
This is a drain pump for your washing machine. This part funnels out water from the washing machine during the draining process of the cycle. This model is white and has a plastic shell. The drain pum...
Remove back cover and with a light and a mirror the screws can be identified. Three hold this pump on. Remove electrical connection then the pump. So also remove the corrugated connecting boot by undoing three clamps. Clean and reassemble
Looked up on YouTube repair procedures and found enough to point me in the right direction. I am experienced in auto and appliance repairs and felt this would be easy even without YT but it helped me prepare tool list as I live 2K miles away from the family. Though YT was not exact machine, it was close enough to get me started as it wa
... Read moresn't rocket science. Once the machine was disassembled and bearings/gasket removed, I found a local bearing supplier which matched parts and started re-assembly. Total machine work time was approximately 7 hours and it runs like new!
A couple of tricks found on YT was putting bearings in freezer prior to assembly for potentially "shrinking" to ease installation, red lock-tite, and using a "good" liquid wrench lubricant for removing the inner rusted bearing.
It's not rocket science and I saved repair technician cost or purchasing a new $1100 washer. My costs were $113, and joy of a successful fix! What did we have to lose!!
Shut off the water to and unplugged the washing machine, Removed the water hoses and the top panel of the machine. Valve is located at the rear, top left, of the machine where the water lines connect to the washing machine. Disconnected the electrical connections, connectors are COLOR CODED, to the valve (4). Disconnected one hose clamp f
... Read morerom the hose nearest to the left side and near the rear of the washer, disconnected the hose. Remove one screw located on the right of the valve assembly. Remove the valve assembly, disconnected the second hose from the valve assembly. Connected the hoses to the new valve assembly. Installed the valve assembly into the washer. Re-connected the electrical connectors. Remember the connectors are color coded. Connect water hoses, turn on water and check for leaks. Re-assemble washer. Plug washer in.
