Your coupon for will be reflected when you check out!
✖
Your coupon for
✖
Hello!
You're visiting the PartSelect site in U.S.
Would you like to shop on the Canadian site?
Stay on this site
Go to Canadian site
✖
Model Number Locations
1Select Category Type
Select Category Type
2Select Product Type
Select Product Type
3Select {MODEL} Type
Select {MODEL} Type
Sample Model Number Tags
Model numbers can be made up of numbers (1005400, for example) or a combination of letters and numbers (LAT1000AAE). The model number will most likely appear on either a paper sticker or a metal plate. Your appliance's model number tag may look similar to the sample model number tags shown here (model number highlighted in yellow):
GDWF460V00SS General Electric Dishwasher - Overview
Save your modelModel Saved!
Save your model for later to make things easier.
Model has been saved to My Models. If you're not signed in, your lists are available on this device and will expire within 30 days.
Model has been saved to My Models.
This upper spray arm assembly is designed to distribute water evenly throughout the upper section of your dishwasher during the wash cycle. If you're experiencing poor cleaning results or uneven water...
Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Greg
December 26, 2019
Dishwasher will not cancel, unlock or reset. Runs continually going through cycles. Had to switch breaker off to open door.
For model number GDWF460V00SS
Hi Greg,
Thank you for your question. If the dishwasher is running continuously, you will need to check the electronic control board and the heating element to verify which part is causing the issue. You will need to inspect the electronic control board for signs of damage or burn marks. If it shows any of these signs you will need to replace it. You will need to test the heating element with a multi-meter. Set your multi-meter to the X1 setting and touch the probes of the tester to the terminals. The reading should be between zero and infinity. If you get a different reading, the element will need to be replaced. We hope this helps. Thank you and have a great day!
2 people found this helpful.
Did this question help you?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
Unsnapped the old middle basket, but then still having difficulty getting one side of the old basket to fit in the grooves on the new middle basket. Have tried it several ways, but still just does not seem to be the right fit on that one side.
