G2650HH (G 2650 HH 1.194-508.0) Karcher Pressure Washer - Overview

Spill Valve

★★★★★

★★★★★

(3)

This spill valve is for pressure washers. Spill valve opens when water flowing through the pump gets too hot, releasing the hot water in exchange for cooler water.

Oil Sealing 12x20x4/6 This OEM Grooved Ring is a 12 x 20 x 4/6 rubber ring which can be installed with a screwdriver and wrench set. Installation is rated as "Medium" difficulty. It attaches in the cylinder head and is use... Add to cart

Suction Valve Complete Genuine Karcher replacement part, it is sold individually. This part along with the piston controls the flow of water through the pump assembly. This part has a tendency to wear out. It may be wise t... Add to cart

Grooved Ring

★★★★★

★★★★★

(1)

Genuine Karcher replacement part, this item is sold individually. This part acts as a seal to keep the oil in the reservoir and the water in the pump form contaminating each other. It is installed on the piston. Add to cart

Pressure Spring This is a high-quality pressure spring that is made for use with Karcher pressure washers. It is an authentic item that is supplied from the original manufacturer. The spring applies tension on the pi... Add to cart

Trigger Gun, Al Bit

★★★★★

★★★★★

(2)

This is a genuine OEM sourced replacement part designed for use with Karcher pressure washers. It is the essential part of the unit allowing to direct and control the spray. This is a trigger gun with... Add to cart

Washer This is a Genuine OEM Authorized replacement part used on Karcher Pressure Washers. This part is made out of Rubber Material and it is Sold Individually. This Washer fits on top of Grooved Ring and pr... Add to cart

Qh Wheel Assy, 10-inch Gray St This high quality wheel and tire assembly is a genuine manufacturer sourced replacement part that is specially produced for Karcher pressure washers. It is the wheel that supports and helps to move yo... Add to cart

O-ring Seal 80,0 X 3,0 -nbr 7 It is an OEM item which is made for Karcher pressure washers. This component provides an air-tight seal for the pump housing. Over time the material will wear out and it may begin to crack eventually ... Add to cart

Drain Plug Only For Replacemen This is a drain plug for different models of pressure washers. It is used to seal the check valve for the engine of the pressure washer and features an O-ring that can deteriorate over time. Failing t... Add to cart

Radial Shaft Seal Ring A26x37x It is a genuine OEM approved seal which is supplied for use with Karcher pressure washers. This replacement part is used to create and air-tight seal for the rotary shaft, over time the material may b... Add to cart

Washer This is a genuine replacement part sourced from the original manufacturer for use with pressure washers made by Karcher. The washer goes between the sleeve and the grooved ring. A screwdriver and a wr... Add to cart