Your coupon for will be reflected when you check out!
✖
Your coupon for
✖
Hello!
You're visiting the PartSelect site in U.S.
Would you like to shop on the Canadian site?
Stay on this site
Go to Canadian site
✖
Model Number Locations
1Select Category Type
Select Category Type
2Select Product Type
Select Product Type
3Select {MODEL} Type
Select {MODEL} Type
Sample Model Number Tags
Model numbers can be made up of numbers (1005400, for example) or a combination of letters and numbers (LAT1000AAE). The model number will most likely appear on either a paper sticker or a metal plate. Your appliance's model number tag may look similar to the sample model number tags shown here (model number highlighted in yellow):
Model has been saved to My Models. If you're not signed in, your lists are available on this device and will expire within 30 days.
Model has been saved to My Models.
REMOVAL 1 ) POWER SWITCH ASSY DOWN AT BREAKER BOX 2 ) LOWER FILTER COVER BY PRESSING FRONT CORNERS, LET HANG 3 ) REMOVE FILTERS 4 ) UNSCREW 2 #2 PHILLIPS HEAD SCREWS LOCATED AT THE REAR OF THE PANEL HOLDING PANEL TO HOOD BODY 5 ) SLIDE PANEL TO THE REAR TO DISENGAGE 6 ) REMOVE SELECTOR KNOBS FROM KNOB AS
... Read moreSY (EXTEND KNOBS AND WIGGLE FREE) 7 ) REMOVE 2 #1 PHILLIPS HEAD SCREWS HOLDING KNOB ASSY TO SWITCH ASSY, LOCATED INSIDE KNOB ASSY 8 ) UNSCREW THREADED SLEEVE ON KNOB ASSY 9 ) REMOVE KNOB ASSY INSTALLATION 1 ) DISASSEMBLE NEW PART INTO COMPONENT PIECES 2 ) SLIDE RETAINER PORTION OF KNOB ASSEMBLY THROUGH APPROPRIATE HOLE IN PANEL 3 ) SCREW THREADED SLEEVE ONTO RETAINER 4 ) ATTACH KNOB ASSY TO SWITCH ASSY USING 2 # 1 PHILLIPS SCREWS 5 ) INSERT SELECTOR KNOBS INTO KNOB ASSY, MAKE SURE THAT THE MARKED (LIGHT OR FAN) KNOB CORRESPONDS TO THE CORRECT SWITCH 6 ) INSERT TABS ON FRONT OF PANEL INTO HOOD BODY 7 ) INSERT 2 #2 PHILLIPS SCREWS INTO REAR OF PANEL TO ATTACH TO HOOD BODY 8 ) REINSERT FILTERS 9 ) RAISE AND SECURE FILTER COVER 10) POWER BREAKER BACK ON
RECOMMEND TEST AFTER INITIAL ASSEMBLY BETWEEN STEPS 5 AND 6. GOOD LUCK
