Your coupon for will be reflected when you check out!
✖
Your coupon for
✖
Hello!
You're visiting the PartSelect site in U.S.
Would you like to shop on the Canadian site?
Stay on this site
Go to Canadian site
✖
Model Number Locations
1Select Category Type
Select Category Type
2Select Product Type
Select Product Type
3Select {MODEL} Type
Select {MODEL} Type
Sample Model Number Tags
Model numbers can be made up of numbers (1005400, for example) or a combination of letters and numbers (LAT1000AAE). The model number will most likely appear on either a paper sticker or a metal plate. Your appliance's model number tag may look similar to the sample model number tags shown here (model number highlighted in yellow):
Model has been saved to My Models. If you're not signed in, your lists are available on this device and will expire within 30 days.
Model has been saved to My Models.
The single rack roller kit comes with one axle/clip and one wheel/roller. The rack wheel is designed to allow the rack of your dishwasher to roll in and out. If the rack will not complete this task, o...
This grey OEM dishwasher tub gasket is a 73" grey rubber part that creates a seal around the dishwasher to prevent any water leakage during a cycle. If it's damaged or broken, you'll start seeing wate...
This spray arm is a genuine OEM replacement part for your dishwasher. This spray arm is for the upper part of your dishwasher. No tools are required for this repair, simple remove the rack stops and u...
The silverware basket, used for dishwashers, is in the bottom dishrack. The lower dishrack basket is used to hold eating utensils such as spoons, forks, and knives, and other small tools. If the baske...
The heating element nut is used to connect the heating element to the dishwasher tub. If water is leaking from underneath your dishwasher, you may need to tighten or replace the heating element nut. R...
This lower dishwasher spray arm assembly is designed to distribute pressurized water across the lower rack, helping ensure thorough and consistent cleaning of dishes during each wash cycle. Engineered...
This part is a replacement spray arm support for your dishwasher. It is made of white plastic and is approximately 3 inches long, 1 inch wide, and 3 inches tall. This is the support for the lower spra...
The upper dishrack roller and axel kit comes with two pieces, a wheel and an axle. This kit is made for your dishwasher. Both pieces measure to be roughly one square inch each, they are made entirely ...
This door seal is for dishwashers.
Door seal seals the gap between the opening to the dishwasher tub and the outer edge of the door.
After installing the door seal, shut the dishwasher door and ...
If your dishwasher is leaking or not draining properly, you may need to replace the drain hose. The drain hose connects to the pump located below the lower spray arm and aids in proper dishwasher drai...
This dishwasher door latch assembly is a critical component designed to ensure safe and efficient operation. It features an integrated switch that functions as an on-off mechanism, preventing the appl...
This fold-down fence with clips is designed to help secure dishes in place during wash cycles in compatible Frigidaire dishwashers. Installed on the rack, it provides added support for smaller or ligh...
$21.85
Special Order
Questions And Answers for FGID2466QF9A
Ask our experts a question about this model and we'll get back to you as soon as possible!
4 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Debbie
February 7, 2025
Door won’t stay partially open when not in use
For model number FGID2466QF9A
Hello Debbie, thank you for you question. The issue may be due to Hinges PS12365372 that are stiff or stuck so that the door closes tight. Or, perhaps the latch is malfunctioning PS16218716. We hope this helps.
Is the lower spray arm supposed to rotate? Every time I open the door its in the same position and the lower dishes sometimes are not clean
thanks very much
For model number FGID2466QF9A
Hello Blaine, thank you for contacting us. The lower spray arm rotates and sprays water to clean the dishes inside the dishwasher tub. If it is not rotating, the issue is most probably with the lower spray arm, part number PS11770610. We would recommend replacing it to solve the problem. Glad to be of help!
Hello, my dishwasher is having issues. When I try to run a cycle after about 20 mins I get a burning plastic smell, then shortly after that it will trip the gfci or the breaker it self. It will run on the rinse only to empty all the water. Thanks for the help.
For model number FGID2466QF9A
Hello Brad, thank you for your question. If you notice a burning smell or an outlet smell, it may be a sign that your circuits are overloaded and need attention from a qualified electrician. GFI may trip if you connect malfunctioning or defective appliances. Loose, corroded wires or connections may also be to blame which will give the burning smell.. Once the GFCI outlet senses an overload, it trip will trip the GFI. Good luck with your repair.
Did this question help you?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
Repair was simple. I unscrewed the old grommet which held the old spray arm and screwed-on the new one. About 30 seconds was required. Other people having this problem should note that the spray-arm is made of three pieces which are inseparable when the arm is new. The arm is sold in this form. However, when your machine is having th
... Read moree problem that the arm falls off, the three pieces become separate. When you want to replace the spray arm, only one new part needs to be ordered because this part encompases all three components.
I removed old tub gasket, which the door presses against to make a seal, and put the new one in. Flat tip screwdriver was used to gently press gasket in.
