FDB510LCS0 Frigidaire Dishwasher Parts & Repair Help | PartSelect
Models > FDB510LCS0

FDB510LCS0 Frigidaire Dishwasher - Overview

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
(126)
PartSelect #:PS9495545
Manufacturer #:809006501
This gasket goes on the bottom of the dishwasher door to create a tight seal between the tub and the outer edge of the door. If the gasket is cracked or broken, it will need to be ...
$12.82
In Stock
(15)
PartSelect #:PS452448
Manufacturer #:5300809640
The single rack roller kit comes with one axle/clip and one wheel/roller. The rack wheel is designed to allow the rack of your dishwasher to roll in and out. If the rack will not c...
$12.84
In Stock
(27)
PartSelect #:PS8260227
Manufacturer #:154827601
The door gasket provides a water tight seal between the tub and the door, to keep water from leaking out of your dishwasher. If your dishwasher is leaking you may need to replace t...
$18.13
In Stock
(60)
PartSelect #:PS8760885
Manufacturer #:808602302
This white lower dish rack assembly comes with eight light-gray rollers for easy access. The dish rack is approximately 21 inches wide x 22 inches deep. The dish rack holds dishes ...
$70.83
Special Order
(37)
PartSelect #:PS1990907
Manufacturer #:154637401
This water inlet valve is usually located behind the lower kickplate panel in either the right or left corner of the dishwasher. The attaching solenoids on the valve open and close...
$33.98
On Order
(2)
PartSelect #:PS11770690
Manufacturer #:5304507405
Sold individually. Grey in color.
$5.62
In Stock
(17)
PartSelect #:PS979850
Manufacturer #:5304442173
No longer available in Almond. Handle is white in color. This door latch prohibits the dishwasher from operating when the door is open. The gasket is used around the door to keep t...
$47.92
On Order
(16)
PartSelect #:PS10062929
Manufacturer #:5304498211
The upper dishrack is used to hold your dishes in place while the dishwasher goes through the wash cycles. Over time the dishrack can become damaged, start to rust, or be missing r...
$69.33
In Stock
(17)
PartSelect #:PS1524955
Manufacturer #:154568001
Located on the lower half of the dishwasher, the lower spray arm rotates and sprays water to clean the dishes in the washer. It does this when water is pushed through the spray arm...
$36.19
Special Order
(8)
PartSelect #:PS1524878
Manufacturer #:154106202
The heating element nut is used to connect the heating element to the dishwasher tub. If water is leaking from underneath your dishwasher, you may need to tighten or replace the he...
$5.13
In Stock
Questions and Answers for FDB510LCS0
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
1 question answered by our experts.
Sort by:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Water leaking from Inlet Valve

  • Customer: CHRIS from ROANOKE, VA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers, Socket set, Wrench set
  • 603 of 614 people found this instruction helpful
Remove the bottom cover plate. Disconnect the water inlet and black rubber hose. Remove 2 mounting screws. Pull out electrical connector. Reverse order. Be sure to get the brass inlet connector really tight so it won't leak. I did the final tightning after the part is mounted. Not a bad repair at all. The only problem was that it leaked in the first ... read more

Lower Rack Roller Missing

  • Customer: Sandra from Mount Vernon, WA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 367 of 371 people found this instruction helpful
Took the roller out of the package, snapped it into place. Less than 15 seconds. Works good as new. read more

Bottom Door Seal fell apart and started leaking.

  • Customer: Scott from Flowood, MS
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 319 of 355 people found this instruction helpful
First I opened the door all the way. Second I reached down to the bottom gasket then grabed it on the right end of the seal that is on the right side of the door. Then I pulled the end outward from the bottom of the door toward the heater coil in the bottom of the washer. It came out real easy. You see it just snaps into a little plastic groove under the doo... read more