This is an OEM door switch, which works with dishwashers.
$47.15
Special Order
Questions And Answers for FDB2410HIC2A
Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Frank
January 22, 2020
An error message keeps flashing and thus the washer will not run. I am a senior citizen so the washer doesn't get much use. I think I purchased it in 2011 and have already replaced the circuit board two years ago. All of my appliances are Frigidaire but my patience with this product is growing thin. If this is the circuit board again I think you should replace it free of charge.
For model number FDB2410HIC2A
Hello Frank, Thank you for the question. Sorry to hear you are having issues with the appliance. In order for us to help you trouble shoot, we will need to know what the error message is that you are getting. Also as far as having the appliance replaced, you will need to make contact with Frigidaire. We hope this helps.
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
Remove front Fascia on floor, use AC sniffer find hot wires into unit. Flip circuit breaker at panel. Verify no AC, shut water valve off on Dishwasher supply. Disconnect two valve wires to solenoid. Use wrench set to find proper size and use to remove supply line. Unscrew two Phillips sheet metal screws that hold valve support bracket and
... Read more remove bracket with it now being held in by water inlet valve hose to interior wall of Dishwasher. Use Tin Snips to cut off metal band securing hose to old water inlet valve. Place new valve onto inlet hose, secure with new hose clamp (you must supply) tighten hex nut on clamp till water tight. Fasten wires onto the solenoid and mount assembly support bracket to dishwasher. Now connect water supply line after wrapping threads with pipe dope tape fasten and secure nut with adjustable wrench till water tight open supply valve and look for leaks with a flash light. If no leaks, reset breaker and test run and drain. No leaks replace fascia and have a Beer great Job saved $850 min. on a new dishwasher!