Quick Question!

Have you ever purchased from PartSelect.com before?

Models > DVM1850DM2WW

DVM1850DM2WW General Electric Microwave - Overview

Get Parts and Repair Help for DVM1850DM2WW

If you know the microwave repair part you need, you can browse the list of all parts on the DVM1850DM2WW, or you can search by name or part description. You can also find your part by where it is located on the DVM1850DM2WW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. We’ve also included any installation videos we have for DVM1850DM2WW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the DVM1850DM2WW

[Viewing 1 of 1]
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$6.36

Halogen Light Bulb - 120V 20W

This lightbulb is located on the inside of your microwave. The bulb is behind the top grill. It will need to be replaced when it has burnt out and no longer works. Unplug the unit....

$7.28

Light Bulb - 40W 130V

This light bulb is a 40 watt, 130-volt clear appliance light bulb that is manufactured to fit microwaves with small-base light bulb sockets. The light bulb illuminates the inside of the microwave while the microwave is running. You may need to replace this part if the existing one is burnt-out or broken. If the existing light bulb is broken, disconnect power to microwave and remove the bulb base with a pair of needle nose pliers. This is a common wear item, so it is recommended to order a spare. These light bulbs are sold individually.

$13.51

Light Socket - 250V 75W

This light bulb socket that is used in microwaves. The socket is meant to fit small-base light bulbs. * Please note: The light bulb is not included with this part and is sold separ...

$22.12

Secondary Door Switch

The secondary door switch is a simple on/off mechanism that stops the microwave from operating when the door is open. The switch monitors the door latch position, and communicates whether the door is open or closed to the electrical control board. This door switch is approximately 1 inch long, and has 2 metal prongs called terminals that extend out of its body. Common symptoms related to a faulty secondary door switch include: microwave will not turn/shut off, or the microwave will not heat properly. NOTE: Before you begin this repair, first make sure your microwave is unplugged, and that your capacitor is discharged. A capacitor stores large amounts of electricity even when your microwave is unplugged.

$10.61

Glass Light Lens

The microwave glass light lens protects the light bulb inside the appliance. It is clear in color and measures approximately 6-1/2 inches long, and 2-1/2 inches wide. You may notic...

$20.30

Monitor Door Switch

Unplug your microwave before attempting this repair. You will need to remove the grill, which is held into place by two screws at the top of the grill (open your microwave door before doing this). Remove the grill. Remove the screw on the left holding the control panel in place. Loosen the screw behind the panel. You should now be able to lift the panel up and pull forward to detach. You will find the door switch by removing the screws to detach the switch assembly. Press on the release tab to remove the middle switch. Disconnect the wire connector to release the old switch.

$10.14

Glass Turntable Coupler

This part accepts a D-shaped motor shaft.

$66.80

Glass Cooking Tray

This tray rotates in your microwave ensuring more even temperatures and is approx.14-1/2 inches in diameter.

$47.68

Grease Filter

This metallic vent hood filter collects grease particles in the air from cooking. Sold individually.

$37.37

Diode

This part allows power to go one way only.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

light worked, timer and control pad worked, but no turntable, no heat, no noises of any sort, just didn't start up

  • Customer: Marla from Arlington, TX
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 226 of 258 people found this instruction helpful
Noted on partselect.com that someone else with this problem, found it to be secondary door switch. There are three door switches in this model, but online info noted that one of the three might feel "soft" (in my case, one switch clicked in a rather "jiggly" way, the other two were strong decisive clicks.) To access the door switches on this model was the ... read more

Light bulb out, tried to remove, lamp socket broke

  • Customer: Gene from Urbana, IL
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 181 of 205 people found this instruction helpful
Above the stove mounted microwave. I dropped the lens cover from under the bulb and tried to remove the bulb. The bulb separated from the base. I tried to remove the base with a pliers and the lamp socket broke. I ordered the parts and dropped the bottom cover of the unit down (5 screws). Removed 1 screww from the lamp socket, unplugged the wires and took it... read more

Lens cracked and bulbs burned out

  • Customer: Mark from GRAND BLANC, MI
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 205 of 280 people found this instruction helpful
First I removed the single screw holding the lens assembly in place. Then I lowered the assembly and tilted it until it came out. To remove the existing cracked glass lens there were four tabs bent down on it. By hand I lifted each tab just enough to remove the broken lens. I then replaced the broken lens with the new one and re-bent the tabs down by han... read more