- Customer: David from Westford, MA
- Difficulty: Really Easy
- Time to Complete: 15 - 30 mins
- Tools Required: Screw drivers
- 130 of 150 people found this instruction helpful
Removed the oven door by opening slightly, then pic door up to remove. Remove 2 screws holding oven sensor in place, gently pull on sensor to remove, had to remove about 8 inches to get at plastic connector. Unplug connector, had to use an adapter cable supplied with the PartSelect kit to install new sensor, push cable back into opening, reinstall 2 screws. ...
read more
- Customer: DENISE from GERMANTOWN, TN
- Difficulty: Really Easy
- Time to Complete: Less than 15 mins
- Tools Required: Screw drivers
- 58 of 61 people found this instruction helpful
First I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires. I threw away the old pieces.
Then I connected the two wires on the new element. I pushed the wires back in the insulation in the wall of the cabinet. Then I inserted the two screws and tightened them in.read more
- Customer: charles from marstons mills, MA
- Difficulty: Really Easy
- Time to Complete: Less than 15 mins
- Tools Required: Screw drivers
- 61 of 77 people found this instruction helpful
First I removed the two screws that hold the element in place. I then pulled the sensor out about 3 inches and disconnected the two wires. Next, I connected new sensor and screwed the new sensor back in place. One area for caution. Make sure that the electrical connection is pushed in past the insulation on the back side of the oven. Failure to do so will ...
read more