CR4100 Crosley Microwave - Overview
Sections of the CR4100
[Viewing 4 of 4]
Keep searches simple, eg. "belt" or "pump".
Screw
PartSelect #: PS12349731
Manufacturer #: W11233072
This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch...
$20.95
In Stock
Light Bulb - 120v 25w
PartSelect #: PS11747808
Manufacturer #: WPA3167501
This is a 120 volt, 25-watt light bulb that fits a variety of medium to large kitchen appliances. It functions by illuminating when the appliance door is open. It has a small base with a twist lock. T...
No Longer Available
Refrigerator Screw
PartSelect #: PS11745625
Manufacturer #: WP8281227
This screw is sold individually.
$11.50
Special Order
Range Burner Mounting Screw
PartSelect #: PS2078761
Manufacturer #: 7101P286-60
This burner mounting screw is used for mounting burners of some ranges. It also comes with a thin black spacer made of hard plastic.
$13.60
Special Order
RACK, OVEN
PartSelect #: PS1750619
Manufacturer #: Y02410004
This microwave oven rack is a little over fourteen inches long. It is ten and a half inches wide and is made of metal.
No Longer Available
Questions And Answers for CR4100
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Light Bulb
Using a flat-head screw driver, I removed the 1 screw from the small "door" on the back, upper right corner. Once the screw was removed, it allowed the door plate to "pop" open; exposing the old bulb. I removed the old bulb; replaced it with the new one. DONE!
Parts Used:
-
Terri from Kingsland, TX
-
Difficulty Level:Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
6 of 12 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
burnt out lightbulb for over 20 years
-
Kathtleen from Bristol, CT
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
3 of 3 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Light bulb went out in mictowave
Screwed the new “$40” dollar light bulb back into the recessed socket. The new bulb is much smaller that the original bulb and much harder to get fingers into small area where the bulb went. After several try’s, I got it in.
Parts Used:
-
Linda from BURSON, CA
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:Less than 15 mins
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!