Your coupon for will be reflected when you check out!
✖
Your coupon for
✖
Hello!
You're visiting the PartSelect site in U.S.
Would you like to shop on the Canadian site?
Stay on this site
Go to Canadian site
✖
Model Number Locations
1Select Category Type
Select Category Type
2Select Product Type
Select Product Type
3Select {MODEL} Type
Select {MODEL} Type
Sample Model Number Tags
Model numbers can be made up of numbers (1005400, for example) or a combination of letters and numbers (LAT1000AAE). The model number will most likely appear on either a paper sticker or a metal plate. Your appliance's model number tag may look similar to the sample model number tags shown here (model number highlighted in yellow):
Model has been saved to My Models. If you're not signed in, your lists are available on this device and will expire within 30 days.
Model has been saved to My Models.
This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch...
This screw-type clamp, also known as a hose clamp, is made of metal and is used within various models of washers to secure the tub-to-pump hose and tub/drum of the washer. Without this clamp, the hose...
Used ascrewdriver to bend the metal rail that the roller rolls on. The part that needed to be bent holds the end cap on. Once bent, the end cap pops off. The the old roller can be removed and the new roller instsalled. The rail then needs to be re-bent.
First removed the end cover and clip on the end of the rack slide. Used a flat head screwdriver to push in the clip and carefully pried it out. Then using the same screwdriver, pried up on the rack roller clip attached to the dish rack. Once clip was free of the rack, slid the rack roller off through the front of the slider. Slid the
... Read morenew rack roller into the slider and snapped the roller clip onto the dish rack in the same place the old one was. Carefully twisted the plastic end cover and clip back onto the rack slider. Job complete. The trickest part of the job is removing the rack slider end cover.
