Models > AWN43RSN115TW01 > Instructions

AWN43RSN115TW01 Speed Queen Washer - Instructions

All Instructions for the AWN43RSN115TW01

Leaking water while washer runs

Biggest trick is getting the agitator off. It seems like it is bolted on. I used a piece of braided cotton cord to run under both sides of the agitator and just pulled real hard. It WILL pop off.

Next the old seal will also seem to be attached. The edge is firm but not bolted. A small prybar will help.

Easy repair to do, but it did not fix my problem. I decided to get a new washer rather than go through further disassembly.

Parts Used:

Agitator Drive Bell Seal

John from Roswell, GA
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver

10 of 20 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

unbalanced tub. 2 of the tub suspension springs had rusted out and broken.

Remove front cover. Install springs. The springs are very tight. You might need another person to push and rotate the tub while you pull on the spring to get it installed in the holes. If you need to replace the springs that are in the back of the unit, you will need to disassemble more of the washer.

Parts Used:

SPRING,LEG-TALL TUB

Aaron from PORT ORCHARD, WA
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Nutdriver, Screw drivers, Socket set, Wrench set

1 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Bad tube seals and bearings

Disassembled washer as per directions with seal kit. Removed inner tub. Cut both tub shaft bearing in half; punched out from outter tub. Installed new bearings using .5 inch threaded rod, washer and bolts. Installed new seal on inner tub shaft. Installed inner tube. Re-assembled washer.

Parts Used: