Your coupon for will be reflected when you check out!
✖
Your coupon for
✖
Hello!
You're visiting the PartSelect site in U.S.
Would you like to shop on the Canadian site?
Stay on this site
Go to Canadian site
✖
Model Number Locations
1Select Category Type
Select Category Type
2Select Product Type
Select Product Type
3Select {MODEL} Type
Select {MODEL} Type
Sample Model Number Tags
Model numbers can be made up of numbers (1005400, for example) or a combination of letters and numbers (LAT1000AAE). The model number will most likely appear on either a paper sticker or a metal plate. Your appliance's model number tag may look similar to the sample model number tags shown here (model number highlighted in yellow):
Model has been saved to My Models. If you're not signed in, your lists are available on this device and will expire within 30 days.
Model has been saved to My Models.
This control knob may also be known as the selector knob or the room air conditioner rotary switch knob, and is compatible with your room air conditioner. The part will allow you to shift the rotary s...
This part is located on the drum roller support shaft in your dryer appliance. The exterior of the washer is 1 inch in diameter with a hole in the middle and is made of metal. They are installed along...
This hex nut is an authentic Whirlpool part that is sourced directly from the original equipment manufacturer, and will fit a variety of appliances including ovens, microwaves, refrigerators, air cond...
This motor clip is an original manufacturer replacement clip used to secure the motor in your home appliances. It holds the motor firmly to its housing to prevent shaking and potential damage while th...
Silicone rubber adhesive is a high temperature adhesive that is used for gaskets on dryers and felt seals. It is used on many different appliances for many different application reasons. This silicone...
A zip tie, also known as a cable tie or a wire tie, is a fastening device that holds wires or tubing together. If a machine has wires or tubing that are easily shifted, you need to hold them tightly t...
$7.47
In Stock
Order now and your part arrives by May 21
Questions And Answers for ACQ254XJ1
Be the first to ask our experts a question about this model!
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
Well - first I thought the problem was the capacitor, as that will cause hard starts, especially on an air conditioner (I am no HVAC man, but researched this to find out). Pulled the capcitor (BE CAREFUL - discharge first - It CAN kill you if you don't!). Tested it and found it fine (again - to test - research on the net - VERY easy w/
... Read morea standard Ohm meter).
So - after investigating a few other possibilities, I sat and listened to the thing run and realized it was cycling too fast (trying to kick the compressor on too close to shutting it off, hence the built up pressure was still too high to kick the compressor on easily. Figured maybe the thermostat was causing this (kicking the compressor on before it was "rested").
I was correct. It solved the problem.
To change the thermostat took like 5 minutes.
BTW - CLEAN YOUR COILS - I'M SURPRISED MY WAS EVEN RUNNING! THE COILS WERE FULL OF JUNK. If your coils are dirty the thing is will not run well and will cost you a lot of money to make your room / house cool!
