Your coupon for will be reflected when you check out!
✖
Your coupon for
✖
Hello!
You're visiting the PartSelect site in U.S.
Would you like to shop on the Canadian site?
Stay on this site
Go to Canadian site
✖
Model Number Locations
1Select Category Type
Select Category Type
2Select Product Type
Select Product Type
3Select {MODEL} Type
Select {MODEL} Type
Sample Model Number Tags
Model numbers can be made up of numbers (1005400, for example) or a combination of letters and numbers (LAT1000AAE). The model number will most likely appear on either a paper sticker or a metal plate. Your appliance's model number tag may look similar to the sample model number tags shown here (model number highlighted in yellow):
Model has been saved to My Models. If you're not signed in, your lists are available on this device and will expire within 30 days.
Model has been saved to My Models.
This part is the replacement burner bowl seal or drip pan seal for your range. It is black in color and is sold individually. The burner bowl seal creates a seal between the cooktop and the drip pan a...
Looking for a solution to reignite your GE cooking experience? Our Ignition Spark Switch for Rear Burners could be just what your cooktop needs. Imagine this: you turn your cooktop knob to the Lite ...
Is your GE cooktop not lighting up as it should? We have a solution for you. This Ignition Valve Switch, made specifically for the front burners of your GE cooktop, is designed to fix that problem. It...
The drip bowls of my stove had to be replaced. The tough job about this is that the bowls need to be ordered which we did. The order was sent to my house within a couple days. The drip bowls were replaced and they look and work just fine. The gas stove is about 10 yrs old and it needs the parts special ordered now. I used to wash and use
... Read more a bit of elbow grease but this time it required too much effort. So an easy replacement did the trick.
1. Turn off gas and unplug cooktop 2. Use knife to score underneath glass cooktop 3. Remove burner grills and caps, remove knobs, remove rings to access 3 screws that hold drip bowls. 4. After removing drip bowls carefully lift up on glass cooktop (May have top use knife again to help release silicone ca
... Read moreulk) 5. Remove 2 screws with nut driver that hold the bracket that has the burner attached to it, very carefully tilt burner and bracket to access screws underneath, being careful not to kink gas line 6. Remove 1 screw and loosen the other to rotate bracket enough to access screw that holds igniter. 7. With new igniter installed replace bracket, turn gas on to check for leaks, you can also plug in power and check igniter. 8. Turn gas off and unplug power, turn glass cooktop over and clean old caulking off and recaulk, carefully replace cooktop and make sure holes are centered over burners and knobs. 9. While caulking is still fresh screw new drip bowls in place (May have to move top slightly to center bowls). 10. Once everything is back in place caulk around edge and turn gas and power back on.
took me a a while to find my problem. One burner would not spark to ignite gas burner. From Part Select website I noticed the part that was the problem from the parts diagram. I did not realize it was related to ignition until I saw that. Easy and cheap to fix after that.
