867747980 Kenmore Furnace - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
not draining at end of cycle
First I dismantled the impellers that drive the wash and drain water to see if they were damaged or clogged - I knew the drain hose was not clogged. It seems you can' remove the wash impeller without breaking it..... at least I couldn't.
Since they were ok [i replaced the wash impeller that I broke], it seemed the only other thing could be the timer switch. I replaced it and all was fine again. It replaces by removing the plastic INSIDE panel of the door and quite easily after that.
Since they were ok [i replaced the wash impeller that I broke], it seemed the only other thing could be the timer switch. I replaced it and all was fine again. It replaces by removing the plastic INSIDE panel of the door and quite easily after that.
Parts Used:
-
Michael from Chevy Chase, MD
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers
0 of 1 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!