Models
>
58714012408A
58714012408A Kenmore Dishwasher - Overview
Sections of the 58714012408A
[Viewing 7 of 7]
Manuals & Care Guides for 58714012408A
Click to downloadKeep searches simple, eg. "belt" or "pump".
Dishwasher Bottom Door Gasket
PartSelect #: PS9495545
Manufacturer #: 809006501
This dishwasher door gasket (Bottom Gasket, Gasket, Door Seal, Dishwasher Door Lower Seal) helps prevent water from leaking out of the bottom edge of your dishwasher door by creating a watertight seal...
$21.04
In Stock
Dishwasher Tub Gasket - Gray
PartSelect #: PS8260227
Manufacturer #: 154827601
This grey OEM dishwasher tub gasket is a 73" grey rubber part that creates a seal around the dishwasher to prevent any water leakage during a cycle. If it's damaged or broken, you'll start seeing wate...
$32.38
In Stock
SPRAY ARM
PartSelect #: PS12705424
Manufacturer #: 5304518927
This lower spray arm assembly is a device in your dishwasher that distributes water and detergent during the washing cycle. Its rotating motion sprays water in multiple directions, ensuring thorough c...
$41.25
In Stock
Water Inlet Valve - 120V 60Hz
PartSelect #: PS1990907
Manufacturer #: 154637401
This water inlet valve is usually located behind the lower kickplate panel in either the right or left corner of the dishwasher. The attaching solenoids on the valve open and close according to the de...
$57.03
In Stock
ROLLER TUB Gray
PartSelect #: PS11770690
Manufacturer #: 5304507405
Sold individually. Grey in color.
$13.90
In Stock
Heating Element Brass Nut
PartSelect #: PS1524878
Manufacturer #: 154106202
The heating element nut is used to connect the heating element to the dishwasher tub. If water is leaking from underneath your dishwasher, you may need to tighten or replace the heating element nut. R...
$7.81
In Stock
Single Rack Roller Kit
PartSelect #: PS452448
Manufacturer #: 5300809640
The single rack roller kit comes with one axle/clip and one wheel/roller. The rack wheel is designed to allow the rack of your dishwasher to roll in and out. If the rack will not complete this task, o...
$7.84
In Stock
Dishwasher Drain Hose
PartSelect #: PS9494138
Manufacturer #: 807117001
If your dishwasher is leaking or not draining properly, you may need to replace the drain hose. The drain hose connects to the pump located below the lower spray arm and aids in proper dishwasher drai...
$26.63
In Stock
Door Spring
PartSelect #: PS815938
Manufacturer #: 154430501
This door spring is manufactured for a dishwasher door. The door spring applies tension to the dishwasher door so that the door does not drop too quickly when it is opening. If the door drops too quic...
$35.02
In Stock
Splash Shield Kit
PartSelect #: PS2203346
Manufacturer #: 154701001
This splash shield kit is used in dishwashers and is attached to the lower front corners of the tub. The splash shield is used to prevent water from spraying past the door seal. If your dishwasher is ...
$39.46
In Stock
Detergent and Rinse Dispenser with Cap
PartSelect #: PS1524979
Manufacturer #: 154574401
This detergent and rinse dispenser with cap may also be known as the dishwasher dispenser assembly and is a part for your dishwasher. The function of this part is to attach to the inside door panel of...
$64.80
In Stock
Spring Linkage
PartSelect #: PS420766
Manufacturer #: 154325201
This linkage attaches to the door spring.
$31.44
In Stock
Questions And Answers for 58714012408A
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Symptoms of the 58714012408A
[Viewing 10 of 10]Leaking
Fixed by
these parts
these parts
Show All
Not cleaning dishes properly
Fixed by
these parts
these parts
Show All
Will not fill with water
Fixed by
these parts
these parts
Show All
Door latch failure
Fixed by
these parts
these parts
Show All
Not draining
Fixed by
these parts
these parts
Show All
Will not dispense detergent
Fixed by
these parts
these parts
Show All
Not drying dishes properly
Fixed by
these parts
these parts
Show All
Door won’t close
Fixed by
these parts
these parts
Show All
Noisy
Fixed by
these parts
these parts
Show All
Will Not Start
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Bottom Door Seal fell apart and started leaking.
First I opened the door all the way. Second I reached down to the bottom gasket then grabed it on the right end of the seal that is on the right side of the door. Then I pulled the end outward from the bottom of the door toward the heater coil in the bottom of the washer. It came out real easy. You see it just snaps into a little plastic
... Read more
groove under the door. I then cleaned up the area for food and soap particules. I then placed the new gasket in place by lining up the notch toward the right end with the piece of plastic that encloses the right end of the plastic notch on the bottom right end of the door. Then push it in untill it stops going into the notch. It snaps in but does not make a snaping sound. It just won't go in no more.
Read less
Parts Used:
-
Scott from Flowood, MS
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
381 of 427 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
dishwasher was leaking water
I removed old tub gasket, which the door presses against to make a seal, and put the new one in. Flat tip screwdriver was used to gently press gasket in.
Parts Used:
-
Charles from Milton, FL
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
175 of 200 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Leak in the water inlet valve/solinoid
1. Shut off water supply.
2. Removed inlet water hose where it connects to the vavle assembly.
3. Removed the two bracket screws holding the assembly to the frame, and detached the electrical connection from the solinoid.
4. Removed the inlet hose adapter connection from old valve and installed into new valve.
5. Att ... Read more ached electrical connection to new valve solinoid.
6. Remounted assembly to the frame.
7. Re-attached the inlet water hose to the hose adapter connection on the valve.
8. Turned on the water, washed some dishes.
2. Removed inlet water hose where it connects to the vavle assembly.
3. Removed the two bracket screws holding the assembly to the frame, and detached the electrical connection from the solinoid.
4. Removed the inlet hose adapter connection from old valve and installed into new valve.
5. Att ... Read more ached electrical connection to new valve solinoid.
6. Remounted assembly to the frame.
7. Re-attached the inlet water hose to the hose adapter connection on the valve.
8. Turned on the water, washed some dishes.
Read less
Parts Used:
-
Mickey from Ooltewah, TN
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Pliers, Screw drivers, Wrench set
154 of 169 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!