512275 Troy-Bilt Trimmer - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
One of the two fuel lines cracked and leaking
Removed the 6 screws holding the red plastic cover, tank, and the old fuel lines from the carburetor. Placed the new tank in the sunlight for a few minutes to soften the new fuel lines. Then attached the new lines to the carburetor and replaced the cover
Parts Used:
-
Robert from ORANGE, CA
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers
6 of 8 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Drive shaft stop spinning
Remove screws from cover insert New parts put everything back together making sure not damage electrical low voltage switch l.
Parts Used:
-
Henry N from DEERFIELD BCH, FL
-
Difficulty Level:Really Easy
-
Total Repair Time:1- 2 hours
3 of 4 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Top drive shaft on my craftsman wc2200 grass trimmer broke
Drive shaft replacement was very easy . Minimal tools were required. Just disconnect the throttle cable, mainly for easier movement of trigger handle. Then remove the guide handle and the trigger mechanism and base. Reassemble reverse order.
Parts Used:
-
Thomas from TICKFAW, LA
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers
3 of 7 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Lost the retainer for my brush cutter on my Troy-bilt brush cutter
Parts fit perfectly. Removed the string trimmer and installed the brush blade. Tightened with an 11mm socket and went to work.
Parts Used:
-
Steven from LOUISVILLE, KY
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Socket set
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!