4011 Amana Microwave - Overview
Sections of the 4011
[Viewing 1 of 1]
Keep searches simple, eg. "belt" or "pump".
Ceramic Fuse - 20 amp
PartSelect #: PS11747931
Manufacturer #: WPM0805101
This microwave fuse is just over an inch in length. It has a white ceramic center, and metal on either end. This is a twenty amp 250-volt fuse, and is used to power your microwave. If your microwave w...
$5.45
In Stock
Screw
PartSelect #: PS11748102
Manufacturer #: WPW10068250
This screw is sold individually.
$8.55
Special Order
Exact Part matches for your search term
[Viewing 6 of 6]
USE WCI P351032
This part number matches the current model number 4011
PartSelect #: PS823801
Manufacturer #: 4011
$141.34
Special Order
Tine Shaft Tube
This part number matches the current model number 4011
PartSelect #: PS16337747
Manufacturer #: 4011
No Longer Available
BUSHING
This part number matches the current model number 4011
PartSelect #: PS17169285
Manufacturer #: 4011
No Longer Available
CDI BOX BRACKET-SNOW
This part number matches the current model number 4011
PartSelect #: PS18429607
Manufacturer #: 4011
$21.62
Special Order
GEAR
This part number matches the current model number 4011
PartSelect #: PS19119279
Manufacturer #: CM9-4011
$108.46
Special Order
PIPE STRAP THERMISTER TEMPERAT
This part number matches the current model number 4011
PartSelect #: PS19452010
Manufacturer #: 4011
$72.22
Special Order
Common Symptoms of the 4011
[Viewing 1 of 1]
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
microwave oven blew fuse
First I removed upper front grill by removing two Philips head screws on top and pulling off. This exposed the Philips head screw which holds control panel in place. After removing screw I pushed up on panel and it came off to expose fuse. With needle nose pliers I removed old fuse and again with pliers held new fuse in position. With th
... Read more
e help of a bladed screwdriver, I pushed new fuse into holder, then replaced panel, screw and grill. This took less than 15 minutes even as one of the wires on control panel pulled out of connection and took some time to locate where to reconnect, otherwise was an easy fix
.
.
Read less
Parts Used:
-
tad from tamarack, MN
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Pliers, Screw drivers
27 of 43 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
microve stopped working
Jenn-Air Microwave would not turn on. Clock worked , light worked, timer worked and would count down .I changed' Part #0813140 Switch, Micr} cost $8.99 plus shippingNow it works Thank You for good advise
Parts Used:
-
Denice from Montgomery, AL
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
15 of 30 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Died while heating lasagna
Removed 4 small star head screws from back of microwave, lifted body off, removed blown fuse and replaced with new one (found where cord enters). This model is stainless inside and out and I like it a lot. It is also sold by Daewoo and a few other manufacturers.
Parts Used:
-
connie from madison, NC
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
9 of 17 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!