Models > 3200 > Instructions

3200 - Instructions

All Instructions for the 3200

Old auger broke

From the parts visual

Parts Used:

Kit, Rubber Blade Replacement

AUGER ASMY 20

John from COLUMBUS, OH
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers, Socket set, Wrench (Adjustable)

4 of 6 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Installed new scrapper blade

Unbolt old one with 4 screws and nuts and replaced new blade with new screws . Very easy fix with new blade and screws . Thanks

Parts Used:

SCRAPER BLADE, 20-INCH

Larry from ULYSSES, KS
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers, Screw drivers

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Blower chute kept falling off

Ordered the plastic chute retainer parts. 3 required. Remove screws from chute to retainer 6 total. Replace chute and hold retainer clip under chute and replace screws. Do not over tighten only made of plastic. Make sure to spray some wd 40 on rim so it moves smoothly. If it doesnt loosen screws a little. Works perfect.

Parts Used:

GUIDE, CHUTE RING

Michael from FAIRMONT, WV
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Socket set

2 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Mixer began to make a noise on speed two and higher

We took our 30 plus year mixer apart. I removed the old grease. There was some crumbly looking grease in the main housing gear section where the nylon gear is located. It looked like it had flour mixed in it. Not certain. Removed as best possible all old grease and applied 6 oz. of new Benalene grease to all of the gears. Now it does not make the slight howl sound.

Parts Used: