1925-1 Briggs and Stratton Generator - Overview

Line-fuel This fuel line is compatible with several different makes and models of small engine equipment and is sold as an individual part. Equipped with the securing clamp, this rubber fuel line is used to tra... Add to cart

Solenoid

★★★★★

★★★★★

(3)

A starter solenoid, also known as a starter relay, is an electrical component that is used within small engine systems to control the starter motor by engaging it when an ignition key is turned - acti... Add to cart

Voltage Regulator

★★★★★

★★★★★

(3)

The OEM voltage regulator or voltage control is a part used to regulate the voltage so it can provide the right amount of power to electrical components. It attaches inside the alternator housing. The... Add to cart

Breaker, Circuit, 20a This circuit breaker is an important safety device found in the control box of your generator. It protects the electrical system from overloads and short circuits by automatically cutting off the elec... Add to cart

E-ring The OEM E-Ring is a silver metal part used to secure the wheel on the shaft. If broken, the wheel may fall off, and the part must be replaced. It is rated as "Easy" to install and requires pliers and a screw driver. Add to cart

Assembly, Holder, Brush The brush holder assembly in your generator keeps the brushes in place, allowing them to touch the rotor. It consists of a plastic brush holder and two carbon brushes with lead wires and attached spri... Add to cart

Brkr Crct 30a 2p

★★★★★

★★★★★

(1)

This is an authentic Briggs & Stratton replacement part that is sourced from the original manufacturer for use with generators. The circuit breaker attaches to the compact control panel. During replac... Add to cart

Cap, Circuit Breaker Add to cart

Screw, M5 - .8 X 10 Taptite This is an original Briggs & Stratton replacement part. The screw is designed by the manufacturer for use in generators. This part is made of metal, and is generally used in securing the bearing cov... Add to cart

Kit,wheel It is a genuine manufacturer-supplied item that is specially designed for Snapper, Briggs and Stratton and Troy-Bilt pressure washers. This is one of the wheels that support the equipment and allow fo... Add to cart

Rectifier, Battery Charge The battery charge rectifier goes inside the control box. It is an OEM from Briggs & Stratton for use in generators. This part is sold individually and is made of metal. A wrench and a screwdriver may...

Outlet, 120/240V, 30A This is available as an individual replacement. The outlet is part of the control panel assembly. When replacing this item a wrench may be needed. It is made of metal and plastic and will need to be r... Add to cart

Complete Handle