All Installation Instructions for Troy-Bilt Lawn Mower 12AEA29L066

Not the exact fit

I had to drill and tap the ends of the axle and put a 1/4” bolt in to fasten the wheels. The hubs were not the same. They fastened differently.

Parts Used:

WHEEL-GEAR 8-INCH INTE

Jay from GERRY, NY
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins

3 of 5 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Front drive wheels were wore out

Unbolted old wheels and bolted new wheels to my lawn mower

Parts Used:

WHEEL-GEAR 8-INCH INTE

Ronald from WAYNE, MI
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Socket set

2 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

The treads on the front drive wheels were worn down to the point that they provided little traction.

Removed a single nut on each end of the drive shaft with the appropriate socket. Wheels then slipped off. Cleaned/polished the shaft with fine sandpaper, lubed with silicone spray, slid on the wheels and reinstalled the nuts with the same socket. Wheels were an exact fit and OEM quality. Done in 15 minutes start to finish.

Parts Used:

WHEEL-GEAR 8-INCH INTE

MICHAEL from Kennewick, WA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Socket set

2 of 5 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

rear axel assembly needed replacement due to broken wheel height lever

Removed rear wheels, cut the old axel of with a sawsall and pulled the assembly out as I didn't want chance breaking the plastic retaining tabs as they can become brittle from age. Break the tabs and you have nothing to hold the new axel assembly in place.
Snapped the new assembly in place and put the wheels back on.

Parts Used: