This is a genuine OEM replacement part, it is sold individually.
This is the front wheel on the models shown below.
There are two of them on each mower.
The wheel has a ring gear on the inside whic...
This is an authentic replacement part manufactured for use with Craftsman walk-behind lawnmowers. The blade is angled to allow the clippings to rotate through the cutting deck to produce fine clipping...
$31.73
In Stock
Order within the next 7 hrs and your part ships today!
The Control Handle is an OEM, metal, black handle used to control the engine. It attaches onto the handle assembly of the mower. If broken you will no longer be able to control the engine, and the par...
$12.65
In Stock
Order within the next 7 hrs and your part ships today!
The Blade Support (Bell Blade Support) fits between the bottom of the blade and the blade bolt to provide support for the blade. It is installed underneath the cutting deck on the blade. Installation ...
$5.72
In Stock
Order within the next 7 hrs and your part ships today!
Designed for use in various models of lawn and garden equipment, this part is not sold as part of a kit or assembly. It is made of metal, is gold in color, and is sold individually. This part may also...
$3.95
In Stock
Order within the next 7 hrs and your part ships today!
Also referred to as a Lock Nut or Flange Lock, this nut is designed for use with various lawn and garden equipment. The purpose of this part is to hold parts in place while resisting loosening when pr...
$3.90
In Stock
Order within the next 7 hrs and your part ships today!
I removed the bail and removed cable from motor! Then it was ready for new parts installation! I attached the cable to the motor and I put the right side of bail in its hole and I then installed cable into the bail and then installed the left side of bail into its hole!! Once that was completed I used two zip ties to cinch down cab
... Read morele to the handle!! Job done!
Removed a single nut on each end of the drive shaft with the appropriate socket. Wheels then slipped off. Cleaned/polished the shaft with fine sandpaper, lubed with silicone spray, slid on the wheels and reinstalled the nuts with the same socket. Wheels were an exact fit and OEM quality. Done in 15 minutes start to finish.