09801-4 Briggs and Stratton Generator - Parts

Fuel Valve With Bushing

★★★★★

★★★★★

(6)

Made of durable rubber and plastic components, this Fuel Valve and Bushing are designed for use in over 150 models of generators and pressure washers. This item is sold as a kit, including the valve a... Add to cart

Breaker, Circuit, 20a This circuit breaker is an important safety device found in the control box of your generator. It protects the electrical system from overloads and short circuits by automatically cutting off the elec... Add to cart

Washer, 5/16 This flat washer is an OEM part that is silver in color, made of metal, and its job in your equipment is to spread load and pressure under a bolt. It can have multiple uses depending on your equipment... Add to cart

Assembly, Holder, Brush The brush holder assembly in your generator keeps the brushes in place, allowing them to touch the rotor. It consists of a plastic brush holder and two carbon brushes with lead wires and attached spri... Add to cart

Vibe Mount, With Washer It is a genuine item that is supplied directly from the original equipment manufacturer for use with Briggs and Stratton generators and pressure washers. The purpose of this component is to reduce the... Add to cart

Rectifier, Battery Charge The battery charge rectifier goes inside the control box. It is an OEM from Briggs & Stratton for use in generators. This part is sold individually and is made of metal. A wrench and a screwdriver may...

Outlet, 120/240V, 30A This is available as an individual replacement. The outlet is part of the control panel assembly. When replacing this item a wrench may be needed. It is made of metal and plastic and will need to be r... Add to cart

Outlet, 120/125v, 15/20a This item is available as an individual replacement part. The outlet is made out of metal and plastic. It may require a wrench during installation. This item will need to be replaced if it breaks. It ... Add to cart

BEARING 5/8 ID Add to cart

Transformer, Idle Cnt Add to cart

Nut, Locking Hex M8 - 1.25 Add to cart

Bearing This is an authentic Briggs & Stratton replacement part. The bearing is commonly found in generators. This part is made of metal, and is used to allow the rotor assembly to spin freely within the st... Add to cart