Food Waste Disposer Seals and Gaskets
- Search your model number to find:
- Genuine OEM parts guaranteed to fit
- Free manuals and guides
- Repair instructions and videos
Popular Food Waste Disposer Seals and Gaskets
Your Price
$23.60
In Stock
Food Waste Disposer Flange Gasket - Fiber
PartSelect Number PS6883604
Manufacturer Part Number WC03X10008
This item is sold individually. The fiber sink flange gasket works with your food waste disposer. This part creates a seal that prevents any water from leaking. It is positioned between the sink flange and the disposal mounting ring. The flange may break apart over time and cause leaking and will need to be replaced. The flange gasket is donut shaped and is 4 inches in diameter. Before beginning this repair make sure the power to the food waste disposer has been disconnected. This is an OEM part that is obtained right from the manufacturer.
Fixes these symptoms
- Leaking
- See more...
Installation Instructions
Donald from Tampa, FL
Leaky GE Disposall
Mount Ring was very difficult to remove. Hammer needed to unlock. Once removed, rubber and fiber gaskets were easily replaced. Cushion Mount did not attach properly to sink flange after many attempts, so Mount Ring was placed too high for hopper to attach. The cushion mount was finally placed on flange correctly (not sure why it attached incorrectly previously) but all is well with no leaks. Dishwasher hose needed to be re-attached after hopper mounted and locked in position.
Read more...
Your Price
$7.47
In Stock
Food Waste Disposer Garbage Disposal Sink Flange Gasket
PartSelect Number PS11742343
Manufacturer Part Number WP4211302
This is a sink flange gasket that is designed for use within various models of sinks and is installed between the strainer and garbage disposal. Made of rubber and measuring approximately 4.5-inches in outer-diameter, this seal can become damaged or worn over time and through extended use can lead to leaks from the disposal, at which time it will need replacing. This seal is sold individually, and because there are two seals in the gasket, you may need to consider acquiring multiple. When replacing this flange gasket, you will likely need a screwdriver and wrench to gain access to the pipes holding this seal. It is important that you disconnect the power and water supply before doing any repairs.
Fixes these symptoms
- Leaking
- See more...
Your Price
$23.60
Special Order
Your Price
$11.77
Special Order
Food Waste Disposer Inner Stopper Gasket
PartSelect Number PS357412
Manufacturer Part Number 4211355
This inner stopper gasket, also known as a splash guard gasket, is an authentic manufacturer replacement part used in food waste disposers. It is a rubber gasket positioned around the perimeter of the inner stopper. It seals the area between the stopper and the disposal housing to prevent water and food waste from leaking out during operation. Over time, the inner stopper gasket may tear, or wear down, impacting its ability to contain water and waste. If the inner stopper gasket fails, water will leak from the unit and damage the surrounding area. The disposer may also be unable to adequately grind waste, leading to clogging and damage. To replace the gasket, twist the inner stopper out of the unit and peel the gasket off. Clean the sealing surface and place the new gasket on to the stopper. Reinsert the inner stopper back into the unit.
Installation Instructions
George E. from Marysville, WA
Your Price
$55.29
Special Order
Your Price
$19.30
Special Order
Your Price
$44.23
Special Order
Your Price
$8.55
Special Order
Your Price
$42.12
Special Order
Your Price
$8.55
Special Order