Drink Mixer Hardware

Drink Mixer Container Support Screw This is an OEM part sourced directly from the manufacturer to be used with Waring blender and drink mixers. The plastic topped metal screw can be hand threaded into the container support. No tools are necessary for the repair. This part is sold individually.

Drink Mixer Pin Switch Actuator This part is made by Hamilton Beach. The Actuator is used in many models of drink mixers. The Actuator is used in conjunction with the Housing Plug (part number 990049700) and the Cup Guide Assembly (990043400) to engage the switch that powers the mixer motor. The Actuator is made of a dense plastic. This part can wear out over time and should be replaced if it no longer engages the switch fully.

Drink Mixer Screw This is an OEM part sourced directly from the manufacturer. The screw is commonly found in Hamilton Beach drink mixers. This part is made of metal, and may be found in various locations in the machine. Please be aware that there are different screws used in the machine. Refer to the parts diagram to be sure of ordering the correct part. You may require pliers when replacing this item. The screw is available as an individual replacement part.

Drink Mixer Screw

Drink Mixer Kep Nut

Drink Mixer Ground Washer

Drink Mixer Washer

Drink Mixer Spacer

Drink Mixer Strain Relief

Drink Mixer Wire Nut This is an authentic Waring replacement part, sourced from the original manufacturer for use with commercial kitchen equipment. The special wire nut is used to cover and join the ends of two wires to complete an electric circuit. This item is available as an individual replacement part.