Drill Caps and Lids

Drill Cord Guard This cord guard is a genuine Makita replacement part, and it is a direct replacement for a damaged or missing cord guard. Power tool cords undergo a lot of stress, and these cord guards help to alleviate some of that stress at the weakest point--right where the cord enters the tool. Over time cord guards will deteriorate and eventually require replacement. Keeping a strong cord guard on your tool will help will cord life. This cord guard is compatible with the tools listed below, but it is not guaranteed to fit any other power tools.

Drill Brush Holder Cap This manufacturer sourced replacement part used on Makita power tools. The purpose of the brush cap is to hold the brush in the brush holder. This cap has external threads that thread into the housing of the tool. Be careful when removing and replacing these, they have a tendency to break. This item is made out of plastic and it is sold individually.

Drill Brush Cap This brush cap is a genuine OEM sourced replacement part. It is commonly used on a variety of Makita power tools. This brush cap helps to secure the carbon brush in the brush holder. This cap has external threads that will thread into the opening in the housing. This item is made out of durable plastic and it is sold individually. It has a convenient slot that makes it easy to secure or remove it using only a flat-head screwdriver.

Drill Brush Holder Cap This is an authentic OEM sourced replacement brush cap. It is specially designed for Makita power tools. The purpose of the brush cap is to secure the carbon brush in the holder. Please note, this plastic item is sold individually. You would need a flathead screwdriver to install or remove this brush cap.

Drill Muffler Cap This is an authentic OEM component from Dynabrade. The plastic muffler cap is compatible with many sander devices. Fitted in the muffler assembly, the part secures the muffler insert. This part is made to help decrease the exhaust noise and capture any excess oil. The muffler cap is sold individually. A wrench and a screwdriver may be needed for the installation.

Drill Battery Cover

Drill Brush Holder Cap This specially manufactured replacement brush holder cap is used on Makita power tools. It is designed to secure the carbon brush in the brush holder. This threaded plastic cap is sold individually. Be careful when removing and replacing these, as they do have a tendency to break or get lost. It features a straight slot to accommodate for a flat head screwdriver to install or remove this cap.

Drill Shield

Drill Cord Guard 8 This cord protector is an OEM part designed for a variety of Makita power tools. It is attached where the power cord meets the tool. This part protects the cord from damage due to pulling, bending, or other strain. This rubber cord protector is sold individually. It does not include a replacement cord.

Drill Hammer Case Cover The hammer case cover attaches to the bumper and to the hammer case. This item is made of plastic and is priced as an individual replacement part. This genuine item is supplied by the original equipment manufacturer for use with Makita impact drivers. A screwdriver and a set of pliers might be helpful during the installation of this part. It may become broken and will need to be replaced.