DeWALT Multi-Tool Parts

DeWALT Multi-Tool Brush Assembly This is a genuine part that is supplied by the original manufacturer for use with Dewalt oscillating multi-tool. The carbon brush conducts an electrical current to the armature and motor. Carbon brushes are a common wear item, and it is recommended to be replaced often. This part is sold individually, though two are required and it is suggested to replace both brushes at the same time. For this repair you will need a screwdriver and a pair of needle nose pliers to aid you.

DeWALT Multi-Tool Trigger Assembly The trigger assembly goes next to the spring and the lock-on button. This item is made of plastic and is available as an individual replacement part. It is a genuine item that is supplied by the original equipment manufacturer for use with DeWALT oscillating multi-tools. A set of pliers may be necessary during the installation of this part. Over time this item may break and will need to be replaced.

DeWALT Multi-Tool Bearing

DeWALT Multi-Tool Flange Assy.

DeWALT Multi-Tool Clamp Lever This clamp lever is an OEM direct from DeWalt. The metal lever is made for use with the DCS355D1 (Type 1) 20V Oscillating Multi-Tool. This metal item is fitted between the gear case assembly and the flange assembly, securing the platen. A hex key wrench is needed for the removal and replacement.

DeWALT Multi-Tool Knob This durable plastic knob is an OEM part direct from DeWalt. The knob is used to secure the depth guide to the desired level in the oscillating multi-tool kits listed below. No tools are required to replace this part. Simply remove the old part by unscrewing counter-clockwise, insert the new knob and turn clockwise to screw in place. One item is included per order.

DeWALT Multi-Tool Brush Holder

DeWALT Multi-Tool Depth Guide It is an authentic item is sourced directly from the original equipment manufacturer for use with DeWALT oscillating multi-tools. This depth guide allows you to more accurately track a marked cut line. The guide arm can also be placed in the guard assembly vertically in order to set the height of a cut. It is an identical replacement for a damaged or a missing component that was installed on a new unit. Make sure to check the owner's manual and the appropriate diagrams for your model to ensure the proper application. One durable metal depth guide with a rubberized tip is included. Replacing it is a simple task that does not require any special tools. Loosen up the knob that holds the depth guide in the block assembly and secure the new part.

DeWALT Multi-Tool Block Assy. This is an original DeWalt replacement part that is manufactured for use with oscillating multi-tools. The special block assembly is an attachment that is used to hold the depth guide. The block assembly can hold the guide at different angles, and can hold the depth guide at an angle so it can be used as a rolling guide for straight cuts. This block assembly is sodl individually.

DeWALT Multi-Tool Torsion Spring