Craftsman Paint Sprayer Seals and Gaskets

Your Price

$13.21

PartSelect Number PS10054429

Manufacturer Part Number XA003300AV

This is the genuine OEM supplied replacement part that is used on Campbell Hausfeld air compressors. A gasket is a mechanical seal which fills the space between the cylinder and the cylinder head. It is recommended to replace gaskets when replacing the cylinder or doing a maintenance repairs on the unit to ensure proper seal. Over time the material may get compressed and crack eventually requiring replacement. Please note this durable composite material gasket is sold individually.

Your Price

$15.64

Craftsman Paint Sprayer Oil Seal

PartSelect Number PS10050910

Manufacturer Part Number ST021600AV

This is an authentic manufacturer sourced replacement part which is specially designed for use with Campbell Hausfeld Air Compressors. The purpose of the oil seal is to prevent oil from leaking between the crankshaft and crankcase opening. When replacing this part make sure that the compressor is unplugged and the air is bleed from the tank. This part is made from high-quality rubber material and is sold individually.

Installation Instructions

Francis from CROWN POINT, NY

seal on the crankshaft was leaking oil

Removed the guard and belt. Heated the flywheel with a propane torch. Careful not to over heat it. Flywheel came off easily with a 3 point puller. Removed the cap and pulled the old seal out. Cleaned the bore in the cap to get all the oil out and dried it. Started the seal into the cap with the letters out. Carefully pushed the seal down into the bottom of the cap with a long socket slightly smaller than the bore. Put a little oil on the inside of the seal and put the cap back on. Reheated the flywheel somewhat again and tapped it back on the shaft with a brass drift. Put the belt and guard back on. Started the compressor. No more oil leaking around the shaft. Read more...

Your Price

$14.56

Craftsman Paint Sprayer Cylinder Gasket

PartSelect Number PS10054434

Manufacturer Part Number XA005700AV

This is a genuine manufacturer-sourced replacement gasket which is specially designed for use with Campbell Hausfeld air compressors. It provides an air-tight seal for the cylinder, please refer to the appropriate diagrams of your model for the correct location and application of this hardware. Over time the material may wear out and begin to crack eventually requiring a replacement, keep in mind this high-quality composite material component is sold individually.

Your Price

$21.27

Craftsman Paint Sprayer Head Gasket

PartSelect Number PS17871363

Manufacturer Part Number XA003500AV

This is a genuine replacement part sourced directly from the manufacturer. The gasket is commonly found in Craftsman air compressors and paint sprayers. This part is made of flexible plastic, and is used to seal the connection between components in the cylinder head. You may require a screwdriver when replacing this item. The gasket is sold as an individual replacement part.

Your Price

$20.61

Craftsman Paint Sprayer Gasket Hd. Top Plt

PartSelect Number PS10054444

Manufacturer Part Number XA007100AV

This genuine manufacturer-sourced part is specially designed for Campbell Hausfeld air compressors. It is an important component which provides a tight seal between connected components. Unfortunately, over time it will wear out and it may begin to crack eventually requiring a replacement. To ensure the correct repair procedure, refer to the appropriate diagrams for your model. Note, this high-quality gasket is made of durable composite material and is sold as an individual item. A wrench set will be needed to perform this repair.

Your Price

$11.16

Craftsman Paint Sprayer Bearing Cap Gasket

PartSelect Number PS10054427

Manufacturer Part Number XA003200AV

This is an authentic part is sourced directly from the original equipment manufacturer. The bearing cap gasket is commonly found in Craftsman air compressors. The purpose of this component is to provide a tight seal between connected parts. Please check the appropriate diagrams of your model for the exact location and the correct application of this part. Note, one durable cap gasket is included.