Chop Saw Power Cords

Chop Saw Power Cord Length: 8' Gauge: 18 Wires: 2 Type: Bare Wire This cord is a genuine DeWalt replacement part. This cord is compatible with the list of models below. This part is made for double insulated tools It is a two wire cord with two prongs and does not need a ground wire. The cord is sold individually. Installation of this part requires the new cord wires to go correctly into wire terminals also routing the cord and wires in the right path can help avoid pinching when the tool case (Plate) is put back into place.

Chop Saw Power Cord Length 8 Foot Length: 6' Gauge: 18 Wires: 2 Type: Bare Wire This power supply cord is a genuine OEM sourced replacement part. It is specially made to supply power from a standard outlet to Makita power tools. A cracked or damaged cord should be replaced before continuing to use the tool. This rubber insulated cord is sold individually. It comes with a rubber sleeve grommet that is not sold separately. Replacing this power supply cord you will need a screwdriver. • Remove the housing screws • Remove the the housing • Disconnect the old cord wires • Remove the old power cord • Secure the new cord in place • Connect the wires • Reassemble and test the new cord

Chop Saw Power Cord It is constructed with tough, thick outer rubber insulation for a long service life. Power Cord Specifications: • 2 Prongs • 2 Wires • 14 Gauge • 10 Feet Long

Chop Saw Cord Protector This cord protector is a genuine DeWalt replacement part and is sold individually. Cord Protectors are designed to slide onto your cord and fit securely at the end, where it's firm rubber will protect the base of the cord from getting bent and pinched, which can expose the wires and become a safety hazard.

Chop Saw Electric Drill Cord Protector

Chop Saw Power Cord (10-foot) This cord is a genuine DeWalt replacement part and is sold individually. It is constructed with tough, thick outer rubber insulation for a long service life. Power Cord Specifications: • 2 Prongs • 2 Wires • 18 Gauge • 10 Feet Long

Chop Saw Power Cord - 8, 16 Gauge, 3-w This cord is a genuine Makita replacement part and is sold individually. It is constructed with tough, thick outer rubber insulation for a long service life. Power Cord Specifications: • 3 Prongs • 3 Wires • 16 Gauge • 8 Feet Long

Chop Saw Cordset This replacement cordset is specially manufactured for band saws. It is an authentic high quality Dewalt item, it is not an aftermarket imitation. If the cord is damaged it is important to replace it before continuing to use the tool. This rubber insulated cord is sold individually. Please note the cord protector is sold separately. You should only need a screwdriver to complete this repair.

Chop Saw Cord Set Assy 120v This is an authentic manufacturer-sourced part which is specially designed for use with Milwaukee saws. The cord is hardwired to the tool in order to supply power from a standard U.S. outlet, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this component. Keep in mind this high-quality rubber insulated cord set assembly is sold separately.

Chop Saw Cord/10ft./16-3 This 10 ft. power cord is a genuine manufacturer sourced replacement part that is specially produced for Black and Decker and Dewalt power tools. It is used to supply electricity from a standard U.S. outlet to the tool. One durable rubber insulated cord is included per order, please note the cord sleeve protector is sold separately.