Brush Cutter Carburetors

Brush Cutter Trimmer Trimer Purge Bulb

★★★★★

★★★★★

3 Reviews

This Primer Bulb is a clear, plastic, individually sold part with an Outer Diameter of 0.720 inches (18.30 mm) and a Height of 0.674 inches (17.12 mm). With Flange: 0.842" (21.40 mm). This part is rated as Easy to install by customers, and attaches to the primer pump assembly. If the part shows signs of breakage, such as cracks appearing due to the bulb drying out, or fatigue, then it must be replaced. Refer to your owners manual/model number to ensure you are choosing the correct part.

Brush Cutter Trimmer Carburetor Kit

★★★★★

★★★★★

1 Review

This carburetor rebuild kit (part number 545081848) is for lawn and garden equipment engines. Carburetor rebuild kit 545081848 includes gaskets and parts for rebuilding the carburetor. Work in a well-ventilated area and drain the fuel from the tank and fuel lines before rebuilding the carburetor

Brush Cutter Carburetor

★★★★★

★★★★★

1 Review

This OEM carburetor mixes the air-fuel mixture to the proper ratio for combustion in your engine. This carburetor is sold individually, is silver in color and metal in material, and is located on the intake of the engine. Issues with your carburetor will cause problems with your engine running, and could cause excessive smoke due to too much gas. This can happen due to corrosion inside the carburetor. Carburetors can be rebuilt easily, and repairing them requires an allen wrench and a screwdriver. When troubleshooting your carb, remove the air filter and pour a teaspoon of fuel into the carburetor. Pull the starter rope, and if the engine starts then quickly dies, the carburetor is likely the problem. When replacing your carburetor, also replace all gaskets when doing so, as they are a one-time use.

Brush Cutter Walbro Gasket/diaphragm Kit

★★★★★

★★★★★

1 Review

This is an authentic OEM replacement kit for use with lawn and garden equipment. Each kit includes the carburetor, cylinder, crankcase, and muffler gaskets. The carburetor gasket seals the area between the carburetor and engine block to prevent the entry of contaminants into the carburetor. The crankcase gasket prevents oil from leaking out of the crankcase. The cylinder and muffler gaskets prevent the combustion and exhaust gases from escaping. If you are experiencing common problems such as leaking, loss of compression, and poor engine performance this indicates that your gaskets may be worn down or damaged and need replacement. Carefully remove the old gaskets and thoroughly clean the mating surfaces where the new gaskets will be installed to ensure a good seal. Install the new gaskets and ensure that they fit properly.

Brush Cutter Repair Kit, Carburetor

Brush Cutter Choke Control

★★★★★

★★★★★

2 Reviews

This is a genuine OEM part. The Husqvarna choke control is made for use with many lawn and garden trimmers. The plastic component is fastened to the carburetor, allowing the operator to manage the engine's fuel and air mixture. A hex key and a wrench may be required for making the repair. The choke control is sold individually.

Brush Cutter Adaptor-carb This is an authentic Husqvarna replacement part manufactured for use with trimmers and brush cutters. The carburetor adapter is used to connect the carburetor to the cylinder. The carburetor adapter is available as an individual replacement part, please note the gaskets are available separately.

Brush Cutter Kit Carburetor Kit

Brush Cutter Carburetor Assembly The carburetor goes next to the filter holder. This part is sold individually and is made of metal. This is an OEM replacement part for use in edgers and trimmers made by Husqvarna. A screwdriver may be required to replace this item. It may become broken and will need to be replaced.

Brush Cutter Carburetor Assembly This replacement carburetor assembly is an authentic OEM supplied part that is specially produced for Shindaiwa gas powered lawn and garden equipment. It purpose is to mix gas and air into a combustible mixture before it goes in the engine. This assembly includes a metal carburetor with a rubber primer bulb and it is sold individually. Please note carburetor gaskets are sold separately. You will need a screwdriver set to complete this repair.