Bear Cat Parts

Bear Cat Blade, Tool Steel Chipper This item has been sourced from the original manufacturer and is intended to be used with chipper/shredders from Bear Cat. The metal chipper blade attaches to the large rotor weldment and is used to cut and chip at the material being fed through the machine. This item is sold as an individual replacement part.

Bear Cat Knife, Rect. Shredder The shredder knife goes next to the knife shaft. This high-quality part is made of metal and is sold individually, but keep in mind that many may be required. The knife is an OEM from Bear Cat for chippers and shredders. It can become dull or broken and will need to be replaced and a wrench may be needed during the replacement process.

Bear Cat Bearing, 1 In. Flushmount This is a genuine part from the original manufacturer. It fits various models of Bear Cat chippers and shredders.

Bear Cat Belt, 29.1 Matched Set This is an authentic replacement part manufactured for use with Bear Cat chipper/shredders. The special belt is used to link the motor drive shaft and the belt drives the rotor assembly. These belts are sold as a kit of two and the kits are sold individually.

Bear Cat Belt, 29" C/s This belt (29" & #34; c/s) is an OEM direct from Bear Cat. The chipper/shredder belt is made of a rubber composite, and is sold individually. Fastened to the engine and sheave, the belt transmits force to related components. A screwdriver and a wrench are necessary for the replacement. It is recommended to purchase a spare as belts can wear out over time and regular use.

Bear Cat Cable, Brake Control

Bear Cat Wheel, 15" Trimmer (black) This is an authentic part that is supplied directly from the original equipment manufacturer for Bear Cat wheeled trimmers. The wheels are attached to the bottom of the pressure washer and are used for transporting it from place to place. This part is made of rubber and metal and is sold individually, though two are required for the unit. For installation, you will need a socket wrench and a screwdriver to aid you.

Bear Cat Pushnut, 5/8 In The pushnut attaches to the wheel assembly. This part is made out of metal and is available individually. It might require a hammer to replace this item if it becomes broken. This is an original Bear Cat part for use in chippers, shredders, and trimmers.

Bear Cat Kit, Chipper Blade

Bear Cat Springbrake This is an OEM part sourced directly from the manufacturer. The brake spring is designed for use in yard equipment from Bear Cat, such as chipper/shredders and stump grinders. This part is made of metal, and may be found in various locations in the machine, depending on model. Please be aware that there are different springs used in the machine. Refer to the parts diagram to be sure of ordering the correct part. This item is sold individually.