Models > DU800DWGQ2 > Instructions

DU800DWGQ2 Whirlpool Dishwasher - Instructions

All Instructions for the DU800DWGQ2
106 - 120 of 173
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
water was leaking ou the door
pulled the old door seal off and pushed the new seal into place and it works great!
THANK YOU!
Parts Used:
Dishwasher Door Gasket - Gray
  • ROSE from ELVERSON, PA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
1 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
seals were leaking,dry rotted from setting five years without using.
I Disconected The 3' hose Behind Impellor.Unscrew Cap Holding Impellor In. Pull It Out, Replce With New One.Put It Back Together In Reverse
Parts Used:
IMPELLER
  • mike from seymour, IN
  • Difficulty Level:
    Easy
  • Total Repair Time:
    1- 2 hours
  • Tools:
    Pliers, Screw drivers, Socket set
2 of 7 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
leaking around door
1-2-3 EASIEST JOB I EVER HAD to DO AND THE WIFE IS PROUD OF ME FINALLY.

THANKS , , ,Bat from WEST SENECA (Buffalo, NY)
Parts Used:
Dishwasher Door Gasket - Gray
  • john a from west seneca, NY
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
1 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
front leak
pulled out the old gasket, aligned and pressed in the new gasket
Parts Used:
Dishwasher Door Gasket - Gray
  • Rod from Dripping Springs, TX
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
I broke one part trying to install
no tools necessary buy instructions would have brrn helpful
Parts Used:
Pin (Lid Hinge)
  • dwight from onaka, SD
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Pliers
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
My Dishwasher Started Leaking Out The Bottom Of The Impeller Assembly.
I went on line and found the partselect website and was able to identify the defective parts using the schematic drawings. I ordered the parts and in about an hour I had reassembled the dishwasher and had it running again much to the joy of my wife and children. (No more washing dishes by hand!). I also purchased the touch-up paint and tine tips and now the washer looks and runs like it did when I purchased it.
Parts Used:
Vinyl Touch-Up White Tine Tips IMPELLER Seal, Drain Cover RING
  • John from Eldersburg, MD
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    1- 2 hours
  • Tools:
    Nutdriver, Pliers, Screw drivers, Socket set
6 of 20 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
leak in dishwasher
This was an easy fix. My husband took out the old gasket and put the new one in. It fit perfectly and no more leak. The part got to us really quickly too and that was nice. No more hand washing the dishes! :)
Parts Used:
Dishwasher Door Gasket - Gray
  • Carolyn from Keithville, LA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Pliers
0 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Not cleaning like it should
Replaced old worn out parts with new ones.
Now it cleans like it should once again.
Parts Used:
Lower Spray Arm with Tower
  • Arnaud from FR SETTLEMENT, LA
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    Less than 15 mins
1 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Will not dispense soap
Remove old spring pin, spring, door
Waste of time effort and money didn't change a thing still won't dispense soap to wash dishes
Parts Used:
Spring, Lid Soap Dispenser Cover Pin (Lid Hinge)
  • D from Sadieville, KY
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Pliers, Screw drivers
2 of 9 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
leaking
put new seal in and it still leaked!hum
Parts Used:
Dishwasher Door Gasket - Gray
  • Roy from matteson, IL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Pliers
1 of 6 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The detergent door won't open fully
Sorry, probably need a spring as the door is fine. While reading other stories about how hard the spring was to get right, I assumed the spring was part of the door assembly.
I'll be calling and returnint the part.



















i'
Parts Used:
Soap Dispenser Cover
  • Bob from Carlsbad, CA
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    Less than 15 mins
0 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
broke water inllet valve
disconnected the water, removed the old valve put in new valve and waah laah it worked .
Parts Used:
Water Inlet Valve
  • ANTHONY from MANITOWOC, WI
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers, Wrench set
2 of 9 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Long spring broke that pulls soap cup open
Opened the door by using a star screwdriver. Pulled the door inside from the outside. Located the broken spring, put in new one (be very carefull to see how the insides are put together..makes life ALOT easier), and carefully put back together.
Parts Used:
Door Spring
  • mark from ickesburg, PA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
5 of 23 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Water in bottom of dishwasher
Disconnected power. Shut off water supply. Took off the front, disconnected copper supply line and flexible water line, removed water inlet valve. Took elbow from old inlet valve and put in on new one. Put new valve in, reconnected water lines, put back front panel. Opened water supply, Flipped breaker back on. Done and it worked!
Parts Used:
Water Inlet Valve Single Hex Head Screw
  • Chris from Pompano Beach, FL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver, Wrench (Adjustable)
63 of 456 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
bottom left side of door leaked
Watched your video and replaced seal in approx. 5 minutes, probably less. Still leaked so I looked at your page for solutions, found out where the air vent was and pried it open, very disgusting mess. With screw driver and long tweezers dug out what I could then poured a mixture of bleach and water in the vent. Totally cleaned it, very white, vent cover went into a bucket of bleach and hot water and it cleaned very well. Put vent cover back on and did a load of dishes, works fine. Thank you for having such a great website, if I ever need help again I will be back. It's a shame someone didn't tell you about cleaning the air vent when you bought the dishwasher.
Parts Used:
Dishwasher Door Gasket - Gray
  • Patricia from Toccoa, GA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the DU800DWGQ2
106 - 120 of 173