CNTRL-ELEC W10427967

Hello Dave, thank you for inquiring. This could just be due to a faulty Door Lock/Latch, part number PS11745083 for your model. You may also want to consider the Electronic Control part number PS5573780 as the cause. Good luck with your repair!

Hello Tom, Thank you for your question. Our sources suggest replacing the electronic control board for your model under part PS5573780 for your model. Hope this helps!

Hello Stuart, Thank you for the question. The error code E01 F01 usually indicates the central control unit is defective and needs to be replaced. If you need help placing an order, customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you!

Hi Jodi, Thank you for the question. The E01 F06 Code is a motor controller not communicating with the CCU controller. The Motor Control Board will need to be replaced not the cntrl-elec . Hope this helps!

Hi Sara, Thank you for your question. This code is referring to an overflow condition or pressure switch has been closed for too long. Check to make sure drain hose is not plugged or kinked and unplug the unit and disconnect power. Check wire harness connections to pressure switch, drain pump, and Central Control Unit (CCU). Check for drain pump failure and clean it of any debris. Check the inlet valve and pressure switch for proper shut off and operation. Replace failed component. Note: If this error occurs, the door will remain locked and the drain pump will run constantly even if 'cancel' is selected. Turn off hot and cold water to faucets and unplug the unit before proceeding. I hope this helps. Thank you and have a great day!

Hello M, Thanks for your question. This type of error typically arises from the door latch, part number PS11752473, which you may want to test with a multimeter for electrical continuity. Replace it if it shows no continuity. Otherwise, consider replacing the control board. I hope this helps.

Hello Don, thank you for getting in touch. This error code indicates an overflow fault, which means too much water is entering your washer. We recommend you check the water inlet valve, part number PS11752082, and the water level switch, part number PS11752436. We hope this is what you were looking for!