Oven Igniter

Hi Kevin, thank you for your question. There are a few parts that could cause this issue in your appliance. First I would say test your igniters with a multi meter to see if they are working correctly or not. They should be reading between 0 - 1100 ohms to be working correctly. The other part you should check would be your oven temperature sensor. That can also be tested with a multi meter and should be reading between 1000 - 1100 ohms. If those three parts are fine however, then the issue may be in your control board or the spark module. I hope that helps. Good luck with your repair.

Hello Tom, thank you for your question. If the sensor has been replaced but the oven isn't heating as it should we would recommend testing the oven igniter and the oven gas valve first. If those parts are tested and are working properly you may have an issue with the electronic control board. I hope this helps!

Hello Brad, thank you for your question. We would recommend testing the igniters and the oven temperature sensor first. If those parts are not faulty you should check the gas and safety valves. I hope this helps!

Hello Doug, Thank you for the question. If the igniter (Plain Heater) is not lighting/glowing it will need to be replaced. Thank you for your inquiry, good luck with this repair!

Hi Tom, Thank you for your question. It is normal for a gas oven once it reaches the desired temperature, to turn off after the oven has reached its desired temperature before shutting off while maintaining a consistent temperature. If it is cycling on and off too quickly the issue is usually a weak igniter. If your wife is the banging the door the issue could be the door switch depending on the model of your stove and it may need to be replaced. I hope this helps. Thank you and have a great day!

Hi Shirley, Thank you for your question. If your stove is not igniting, then the issue is the igniter and you will need to replace it. We hope this helps! Good luck with the repair!

Hi George, Thank you for your question. To verify the correct model number for your range, you will need to check the model number on it. We have included a link that you may reference on where to locate the model number on your range. We hope this helps! If you have any questions, please let us know.

Hello Bill, Thank you for the question. An oven will normally preheat in 12-15 minutes. We suggest testing the Temperature Sensor. Testing the temperature sensor probe on your oven is easy. With the sensor at room temperature, measure the resistance between the two prongs at the end of the sensor connector. The resistance of the sensor should read approximately 1080 – 1090 ohms at room temperature. If you need help placing an order, customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you!

Hello Bob, Thank you for your inquiry. This error code indicates the stove has reached a certain temperature within 5 minutes. Check to see if the ignitor is drawing between 3.2 and 3.6 amps which it needs in order to igniter. Another cause could be the temperature sensor, which you can test with a multimeter. We hope this helps and if you need help placing an order, customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you!

Hello Ernest, thank you for your question. This does sound like the sensor. You can test the sensor with a Multimeter. Testing the temperature sensor probe on your oven is easy. With the sensor at room temperature, measure the resistance between the two prongs at the end of the sensor connector. The resistance of the sensor should read approximately 1080 – 1090 ohms at room temperature. If the sensor is reading at the appropriate level the igniter may be the issue. I hope this helps!