Models > WSM2700RCW > Instructions

WSM2700RCW General Electric Washer Dryer Combo - Instructions

All Instructions for the WSM2700RCW
31 - 32 of 32
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Drum would not turn at full speed, noisy squeak
Top control panel removed; next used screwdriver to lift up dryer top on each side( the top of dryer is attached by clips on the underside) the dryer front panel has two screws, one on each side of inside front(they are easy to reach and near the top of the inside front panel, after removing these two screws we used screwdriver again to pry off front panel as it is attached also by clips on inside of front panel. At this point there is easy access to the drum where the old belt was removed, new belt put in place; removed small panel on back of dryer to access idler pulley and attached new belt through the pulley; turned the drum a couple of times by hand to check if belt was running true on the drum; problem fixed.
Parts Used:
Drum Belt
  • Linda from Edna, TX
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
the dryer belt broke
very simple my husband put it on in no time
Parts Used:
Drum Belt
  • Barbara from Staten Island, NY
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Pliers
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the WSM2700RCW
31 - 32 of 32