Ask our experts a question about this part and we'll get back to you as soon as possible!
3 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Genevieve
October 27, 2021
When I start a cycle, after a few sounds, it immediately goes to "CLEAN" even though it didn't even start the cycle. Tried shutting down the electrical panel breaker for 15 minutes, worked a couple of times but won't work anymore. The times that strategy worked, the cycles went well (water inside, dishes were clean and hot at the end of the cycle) so I eliminated the pump from the culprits list. Is there hope ? What needs to be fixed ?
For model number SHX4AP05UC/05
Hi Genevieve,
Thank you for your question. If your dishwasher is jumping immediately to the clean cycle when you start a cycle, check and see if the water heater cycle is working properly. If the water is not heating properly, then you may need to replace the heat pump. Also, before using the dishwasher, run the hot water in the kitchen sink for a few minutes until it is good and hot. If the heater cycle is working properly, you will need to check the electronic control board. We hope this helps! If you have any questions, please let us know.
Hello David, Thank you for the question. Bosch dishwasher error code E24 is a code that appears when there is an error in the drain. A common solution to solve the issue is cleaning the clogs or straightening the hose. We hope this helps.
Was this helpful?
Thank you for voting!
Tom
July 25, 2021
My program board is not working right and now rinse agent light is flashing. I've even disconnected power. Still won't work. I am assuming i need this control unit??
For model number SHE5AL02UC/06
Hello Tom, Thank you for your inquiry. After researching your model, we would recommend replacing the control board. Good luck with your repair.
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.
