Average Repair Rating: 3.3 / 5.0, 1 reviews.
What's this?
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Dishwasher leaks from door region during washing cycle.
Old door seal appeared ok, no rips and seated evenly all around. Pulled that seal out and replaced with new. Seated new door seal after wetting inserted lip. Tested...leak greatly reduced, but still dripping. Removed seal, placed a rubber rope (same rope used for screening) within the tub recess, then reseated new seal. leak ceased. Also
... Read morereplaced the reservoirs on the left side of the cabinet (guide assembly). Old reservoir had debris within so decided to replace. Used regular pliers for the 3 hose spring clamps underneath, and a pair of large neede nose pliers for the fill flange (regular thread).
Ask our experts a question about this part and we'll get back to you as soon as possible!
2 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Kevin
December 11, 2017
What is the part number for the clip on rollers for the dish racks?
For model number LDF6920ST
Hi Kevin,
Thank you for your question. The axle that allows the roller to clip onto the dishrack is sold with the roller. The part number for the roller with axle is PS3523050. I hope this helps. Thank you and have a great day!
Was this helpful?
Thank you for voting!
Florence
December 5, 2019
Do you have an instruction video for the water inlet guide installation
For model number LDF6920WW
Hi Florence, thank you for your question. We unfortunately do not have a video for installation. Here are some instructions that may help: You will want to remove the upper and lower dishracks. Close your door after. You will have to uninstall your dishwasher. Make sure to shut off the water and the power to the appliance. Remove the lower access panel and sound dampening pad. Disconnect the water supply line from the water inlet valve. There will be water, so you may want to have a towel handy. Remove the junction box cover and make sure to mark the location of the wires or take a photo so you will remember for later. Detach the strain relief next. Then disconnect the drain hose from the pipe so you can push it through the hole in the cabinet. You will have to pull out the dishwasher but be careful not to damage it. Then open up your door and on the bottom left side, remove the inlet cover. You can do this by sticking something in one of the openings, something like pliers, and twisting the part out of place. Close the door again. Get a towel and tip the dishwasher backward gently. Then use pliers to release the clamps on the tube connected to your guide. Then remove your water tube. Slide the switch cover up and out, then disconnect the wires from the guide. You will then have to look at the bottom of your dishwasher, remove the screws holding in the access plate. After removing that plate you will have access to disconnect the wiring for the sensor, and disconnect the fill, drain, and air hoses from the appliance. Once you have done that you can pull out the old water inlet guide. Follow these steps backwards to reinstall the part. I hope that helps. Good luck with your repair.
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.