Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
bottom door gasket replacement/door latch replacement
Need to remove door from hinges to allow to SLIDE gasket thru small lip on door.After using soap and cleaning lip on dishwasher face ,Gasket never feels to grasp lip properly.Identical gasket from old design,just difficult to install.Door latch was also easy to install,BUT LATCH WAS PURCHASED IN LOCKED POSITION.Make sure to roll tumbler in latch ,or it will never lock.
Removed leaking drain hose under the dishwasher from drain pump and sink drain pipe. Fed new hose behind dw connected with new clamps to dw drain pump and sink drain pipe. Put in high loop under sink.
Definately purchase all the wheels (8) as they are smaller than original wheels. Buy the wheel with attached stud. Pull off old wheels and pop these on!
The wheels on our bottom tray to our dishwasher had fallen off from a lot of use here in our office. When the wheels arrived, I just simply snapped them back on. A few had to be snapped on tight, but there were no tools necessary. Overall, a very easy fix.
Removed all wheels, then removed and installed new studs which were designed better than the origional and re-installed. Bottom rack now slides in and out much better.
The wheels were falling off from the bottom rack of my dishwasher.
I ordered 8 wheels, but I really needed just 4.( I am preventing for the future) It was so very simple to place my order and they were delivered in no time. I simply took off the old one, looked at how they were affixed and put the new ones the same way. Less than 2 minutes to do the entire job. I am a "Handy woman".
Dishwasher basket worn our and utensils slipped through bottom
1. open dishwasher, 2. roll out bottom dish rack, 3. remove old silverware basket, 4 place new basket in same spot old basket was in, 5. roll bottom dish rack back into dishwasher, 6. close dishwasher door.
Rubber gasket for sealing top sprayer arm worn out
The repair piece containing the gasket must be unscrewed and the replacement piece is then screwed into place. Use of a wrench is necessary but used gentle compression as this piece is plastic. Also be careful when starting to thread the piece back on as too much pressure may push the part you are threading it onto out of the back of the dishwasher. ( Note that removing the top rack facilitates the job.. This is done by pushing the locks at the end of the roller tracks in and then to the side, opening the tracks for removal of the rack.)